select the lightest wide flange section that can safely support the loading. the beam has allowable bending stress σallow of 33 ksi. do not neglect the own weight of the beam.

What do radio waves and microwaves have in common? both are at the side of the spectrum that has the shortest wavelengths. both are at the side of the spectrum that has the lowest radiant energy. both are at the side of the spectrum that has the lowest frequency. both are found next to visible light on the electromagnetic spectrum.

We all use gps today, even if we don't drive yet. i bet you have been in the car with a parent and they have asked you to get out your phone to find a specific location. in your car, on the phone, you are using a very sophisticated technology. gps satellites circle the earth twice a day in a very precise orbit and transmit signal information to earth. gps receivers take this information and use trilateration to calculate the user's exact location. essentially, the gps receiver compares the time a signal was transmitted by a satellite with the time it was received. the time difference tells the gps receiver how far away the satellite is. now, with distance measurements from a few more satellites, the receiver can determine the user's position and display it on the unit's electronic map. what type of signal is utilized by the gps satellite?

Aroll in a paper machine is powered by a separately excited dc machine. operating point 1 (under load): the roll typically operates at 764 rpm and must provide 301 nm of torque to oppose the load of the paper. the armature voltage is 230v for this operating point operating point 2 (no load): when the load is removed the speed of the roll increases to 900 rpm (the field characteristics are unchanged) la ea dev m (a) calculate the maximum torque (units of nm) that the motor can supply with this applied voltage (b) calculate the value of the armature resistance, ra (in ohms) (c) at operating point 1 (loaded condition), the field current, i, and the total input power (armature field), are measured to be to be 10 a and 28,600 w respectively. use this information to calculate the value of the field resistance, rf (in ohms). (d) (d) at operating point 1 (loaded condition), calculate the motor efficiency. express your answer as a percent to at least 2 significant digits. (d) if the field voltage is reduced by 1/2, calculate the new stall torque (in nm) of the motor (f). if the field voltage is reduced by 1/2, calculate the new no-load speed (in rad/sec)