Physics
Physics, 18.02.2020 04:26, deonceee4671

A parallel-plate capacitor is made of two flat metal plates pressed against a thin slab of dielectric material. The capacitor is connected to a power supply, and a potential difference of 90 V is applied to the plates. With the power supply disconnected, the dielectric material is removed and the potential difference between the plates is measured to be 525 V. What is the dielectric constant of the material that was initially used to fill the gap between the plates?

answer
Answers: 1

Other questions on the subject: Physics

image
Physics, 21.06.2019 14:00, raquelle66
Identify two factors that determine the rate of stream erosion
Answers: 1
image
Physics, 21.06.2019 18:30, aaliyahmaile13
What is the conversion factor between kg/m^3 and g/m^3. express your experimental values for the densities in kg/m^3.
Answers: 1
image
Physics, 21.06.2019 22:00, homework2358
There is a theory that indicates that dinosaurs became extinct when about 65 million years ago, a large asteroid hit the earth surface. dust caused by this collision blocked the sunlight reaching the earth's surface and many forms of life became extinct due to the cold. fearing this threat, how large the radius of an asteroid should you be looking for if the dangerous asteroid size is approximately the same as the one that killed the dinosaurs? available data suggests that about 18% of that asteroid's mass ended up as a dust spread evenly over earth after eventually settling out of the upper atmosphere. about 0.0180 g/cm^2 of dust, which is chemically different than the earth's rock, covered the earth's surface. typical asteroids have a density of about 1.9 g/cm^3. now that we know the size of the asteroid, how much energy was released during impact, assuming all of it was just the kinetic energy of the asteroid right before the impact?
Answers: 1
image
Physics, 22.06.2019 03:00, 03babyj
Which of the following is an example of units for speed
Answers: 1
Do you know the correct answer?
A parallel-plate capacitor is made of two flat metal plates pressed against a thin slab of dielectri...

Questions in other subjects: