Physics
Physics, 17.10.2019 04:00, harvzoie

Acurrent exists whenever electric charges move. if δq is the net charge that passes through a surface during a time period δt, then the average current during this time interval is defined asaverage current = δqδt = q2 − q1t2 − t1.if we take the limit of this average current over smaller and smaller time intervals, we get what is called the current i at a given time t1: i = lim δt→0 δqδt = dqdt. thus the current is the rate at which charge flows through a surface. the current in a wire is defined as the derivative of the charge: i(t) = q'(t). what does bi(t)a dt represent?

answer
Answers: 3

Other questions on the subject: Physics

image
Physics, 22.06.2019 19:30, sierranowe2003
Juliette sets the initial velocity to +10 m/s, the acceleration to zero, and clicks “start.” how can shakina describe the subsequent motion of the car juliette controls?
Answers: 3
image
Physics, 23.06.2019 00:20, dragongacha777
Ahypothetical metal has an orthorhombic unit cell for which the a, b, and c lattice parameters are 0.413 nm, 0.665 nm, and 0.876 nm, respectively. (a) if there are 8 atoms per unit cell and the atomic packing factor is 0.536, determine the atomic radius (in nm). (b) if the density is 3.99 g/cm3, calculate the metal's atomic weight (in g/mol).
Answers: 3
image
Physics, 23.06.2019 07:10, timothyashburn8
50.)the diagram below represents the wave fronts produced by a point source moving to the right in a uniformmedium. observers are located at points a and b. compared to the wave frequency and wavelength observed at point a, the wave observed at point b has a(1) higher frequency and a shorter wavelength(2) higher frequency and a longer wavelength(3) lower frequency and a shorter wavelength(4) lower frequency and a longer wavelength
Answers: 3
image
Physics, 23.06.2019 08:30, lele2010
Industrial processes often require the damping of vibrations. consider a workbench that uses four large ideal springs in place of traditional legs, with each spring supporting one corner of the workbench and exhibiting a force constant of 47500 n/m. this workbench is used when creating products that involve highly unstable chemicals. according to specifications, the acceleration of the manufacturing equipment must be held to less than 22.3 m/s2 for the manufacturing process to proceed safely. the amplitude of vibrations are expected to remain under 0.622 mm throughout. given that the workbench and maufacturing equipment combine to 6.05 kg, find the maximum acceleration expected of the equipment and workbench. (ignore the mass of the springs.)
Answers: 2
Do you know the correct answer?
Acurrent exists whenever electric charges move. if δq is the net charge that passes through a surfac...

Questions in other subjects: