Physics, 10.10.2019 11:00, uticabadgirl

Which type of wave would not be classified as a transverse wave?

Answers: 2

Show answers

Other questions on the subject: Physics

Physics, 22.06.2019 01:30, kaylin28

Astone is dropped with no initial velocity from the top of a cliff and hits the ground a time of 3.9 s later. what is the height of the cliff, in units of meters? you may assume that air resistance is negligible. give the answer as a positive number question 15 a figure skater is rotating at a rate of 200 revolutions per minute. what is the angular speed, in units of rad/s? 200 o 20.9 12000 o 3.33

Answers: 2

continue

Physics, 22.06.2019 05:20, quan5379

Suppose an objects initial velocity is 10m/s and it’s final velocity is 4 m/s. mass is constant. what can best be concluded about the object based in the work-energy theorem

Answers: 2

continue

Physics, 22.06.2019 05:50, gabigraceberg

High schoolphysics 5+3 pts a neon light consists of a glass tube with metal wires at each end. when connected to a high-voltage source, the gas glows. if a fly lands on the glass tube, what will most likely happen? a) the fly will not feel a shock because the glass conducts any free electrons back into the gas. b) electrons will flow directly from the metal wires along the glass and shock the fly. c) the fly will not feel a shock because the glass insulates it from the electrons in the gas and the metal. d) electrons that are moving through the gas will be conducted through the glass and shock the fly.

Answers: 3

continue

Physics, 22.06.2019 07:30, anonymous1813

Some material consisting of a collection of microscopic objects is kept at a high temperature. a photon detector capable of detecting photon energies from infrared through ultraviolet observes photons emitted with energies of 0.3 ev, 0.5 ev, 0.8 ev, 2.0ev, 2.5ev, and 2.8ev. these are the only photon energies observed. (a) draw and label a possible energy-level diagram for one of the microscopic objects, which has four bound states. on the diagram, indicate the transitions corresponding to the emitted photons. explain briefly. (b) would a spring–mass model be a good model for these microscopic objects? why or why not? (c) the material is now cooled down to a very low temperature, and the photon detector stops detecting photon emissions. next, a beam of light with a continuous range of energies from infrared through ultraviolet shines on the material, and the photon detector observes the beam of light after it passes through the material. what photon energies in this beam of light are observed to be significantly reduced in intensity (“dark absorption lines”)? explain briefly.