Now, select the Slits simulation at the bottom of the screen, and Light (red) for the type of wave, as before. Also, make sure there is a barrier with one slit, and use the tape measure as well as the slider bar below the slit to place it roughly 1290 nm away from the light source. Adjust the slit width to 300 nm. Finally, select the start button at the source location to begin producing the waves. Which statement best describes how the intensity of the wave depends on position along the screen? Selecting the Intensity checkbox will show a plot of the intensity on the screen.

answer with step-by-step explanation:

a. ∠j is supplementary to ∠k - true:

(opposite angles of a trapezoid are supplementary which means that they add up to 180 degrees)

b. kl is parallel to jm - true:

(opposite sides are parallel to each other in a trapezoid)

c. jk is perpendicular to kl - false:

(clearly, jk does not make a right angle with kl)

d. jk is parallel to lm - false:

(jk and lm are two lines opposite in direction to each other so they cannot be parallel)

e. ∠j is congruent to ∠m - true:

(the angles on each side of the base are congruent)

f. ∠j is congruent to ∠k - false:

(the angles on the same side but opposite side of the base are not congruent)

i pretty sure it is

what is the answer?

5x + 5

step-by-step explanation:

you should always add the diagrams and graphs we cannot see. this particular question is kind of borderline because we can make a graph for you.

(f + g)x = -x^2 +3x + 5 + x^2 + 2x

(f + g)x = 5x + 5

the graph of z = 5x + 5 is shown below. always use desmos when in doubt.