Engineering, 27.02.2022 03:10, s77969

A combined cycle power plant has a net power output of 214 MW. Air enters the compressor of the Brayton cycle at 100 kPa and 37oC. The pressure ratio is 18, the turbine inlet temperature is 1620 K and the gases leaving the turbine are used to heat the steam of the Rankine cycle to 600oC and 6 MPa. The combustion gas leaves the heat exchanger (HRSG) at 420 K and the condenser pressure is 10 kPa. The isentropic efficiency of the compressor is 91%, the gas turbine isentropic efficiency is 93%, the steam turbine isentropic efficiency is 92% and the pump efficiency is 65%. The condenser sub-cools the water by 10oC (10oC less than the saturation temperature). Using variable specific heat analysis, determine:

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, salazjlove

Which of the following refers to refers to how well the control system responds to sudden changes in the system. a)-transient regulation b)- distributed regulation c)-constant regulation d)-steady-state regulation

Answers: 1

continue

Engineering, 04.07.2019 18:10, 0436500

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

continue

Engineering, 04.07.2019 19:10, juneham

Estimate the change in specific internal energy au and specific enthalpy h from inlet to outlet for ethylene glycol (a liquid) flowing through each of the following devices: (a) a heat exchanger where the glycol temperature increases from 20 °c to 80 °c; (b) a pump operating at about 25 °c and increasing the glycol pressure from 100 kpa to 8 mpa.

Answers: 2

continue

Engineering, 04.07.2019 19:20, dndndndnxmnc

The process in which the system pressure remain constant is called a)-isobaric b)-isochoric c)-isolated d)-isothermal

Answers: 3

continue

Do you know the correct answer?

A combined cycle power plant has a net power output of 214 MW. Air enters the compressor of the Bray...