Engineering, 25.11.2021 15:40, harmonyfern5648

When compared to internal combustion engines: Select one:
O A. the output of Stirling engines can be easily varied.
O B. steam engines take relatively less time to generate pressure.
O C. steam engines do not present an explosion hazard under too much pressure.
O D. Stirling engines run almost silently.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, redrosesxx

Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux

Answers: 3

continue

Engineering, 04.07.2019 18:10, oliviasoreo92

Compute the pressure drop of 30°c air flowing with a mean velocity of 8 m/s in a circular sheet-metal duct 300 mm in diameter and 15 m long. use a friction factor, f 0.02, and pair = 1.1644 kg/m a. 37.26 pa b. 25.27 pa n c. 29.34 pa d. 30.52 pa

Answers: 1

continue

Engineering, 04.07.2019 18:20, maustin5323

Athin walled concentric tube exchanger is used to cool engine oil from 160°c to 60°c with water that is available at 25°c acting as a coolant. the oil and water flow rates are each at 2 kg/s, and the diameter of the inner tube is 0.5 m and the corresponding value of the overall heat transfer coefficient is 250 w/m2. oc. how long must the heat exchanger be to accomplish the desired cooling? cpwater=4.187 kj/kg-candcpengine el=2.035 kj/kg·°c, oil . 120]

Answers: 1

continue

Engineering, 04.07.2019 18:20, miguel454545

Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.

Answers: 1

continue

Do you know the correct answer?

When compared to internal combustion engines: Select one:
O A. the output of Stirling engine...