Engineering
Engineering, 12.03.2021 14:50, tasiajm

g 1. The theory used to determine the maximum power of a wind turbine is (A) actuator theory, (B) Fourier theory, (C) Maxwell theory. 2. The maximum power that can be extracted by a wind turbine is (A) 0.2963, (B) 0.593, or (C) 0.5 of the available wind power. 3. The two types of HAWT are (A) , (B),and VAWT are (C) , and (D). 4. The tower shadow is one of major concern of (A) upwind turbine, (B) downwind turbine or (C) vertical wind turbine. 5. The advantages of VAWT are (A) does not need to turn toward the wind (B) all powertrain components in the ground level, and (C) very stable. 6. The self-starting VAWT is (A) Darrieus wind turbine (B) Savonius wind turbine or (C) straight blade wind turbine. 7. Smaller number of blade will require (A) higher starting speed, (B) lower starting speed, (C) can self-starting. 8. Since air flow is not confined, the interference factors are used to compensate the air flow through the blade and there are (A) and (B) 9. For a self-starting Savonius vertical wind turbine, it has relative (A) high torque or (B) low torque at low wind speed. 10. The overall power generated by a wind turbine can be determined by the linear average wind speed during the period which is (A) True, or (B) False.

answer
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, hadellolo8839
Acompressor receives the shaft work to decrease the pressure of the fluid. a)- true b)- false
Answers: 3
image
Engineering, 04.07.2019 18:10, 0436500
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
image
Engineering, 04.07.2019 18:20, krojas015
Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?
Answers: 3
image
Engineering, 04.07.2019 18:20, rhussein6452
Wiy doeres rere okhn a pump whon working betwon the same pressure range?
Answers: 2
Do you know the correct answer?
g 1. The theory used to determine the maximum power of a wind turbine is (A) actuator theory, (B) F...

Questions in other subjects:

Konu
Mathematics, 21.06.2021 14:00