Engineering, 28.01.2021 14:00, squawk1738

- The length of a cylindrical rod is increased elastically by 1 mm on the application of a certain load. In a rod of the same material but of twice the length and half the radius, the same force will produce an elongation of

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, salazjlove

Which of the following refers to refers to how well the control system responds to sudden changes in the system. a)-transient regulation b)- distributed regulation c)-constant regulation d)-steady-state regulation

Answers: 1

continue

Engineering, 04.07.2019 18:20, samueltaye

Modern high speed trains do not have perpendicular expansion gaps where rails are joined end-to-end any more they are mostly welded together but what might happen if there was a spell of particularly hot weather that causes inspection of the tracks?

Answers: 1

continue

Engineering, 04.07.2019 19:10, shayshay7874

An electric kettle is made out of stainless steel, weighs two pounds (when empty) and is equipped with a heating element that consumes 2 kw of electricity. assuming that the water and the kettle are at the same uniform temperature at any moment of time, calculate the shortest possible time to bring 2 quarts of water from room temperature to the onset of boiling

Answers: 2

continue

Engineering, 06.07.2019 05:20, emmanuel96

The inner surface of a 0.25m thick brick wall of a furnace is kept at 810ºc, when the outside surrounding air is at 22ºc. the convective heat transfer coefficient of the outer surface is 12 w/m2k and the thermal conductivity of the brick is 0.865 w/mk. neglect the convective resistance for the inner side of the furnace and assume that the problem is steady state and thermal radiation is neglected. (a)-sketch the system and calculate the rate of heat loss per unit wall area. (b)-calculate the temperature of the outer wall surface.

Answers: 2

continue

Do you know the correct answer?

- The length of a cylindrical rod is increased elastically by 1 mm on the application of a certain l...