Engineering, 27.10.2020 02:10, mariahgriego4126

Match each scenario with the term it represents. As an engineer designs a new truck, he creates a model that has its sides unfolded so the client is able to see the front view through the center of the drawing.

Kelly has just completed a drawing of a model that allows the client to see the product in three dimensions with every axial view visible. This allows the client to envision the entire product.

John has been working on the design for a new video recorder. At this point he just needs to show the client a sketch of the recorder from the front so that all the functional buttons are visible.

Isometric

Third-angle projection

orthographic

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, leomessifanboy678

The filament of an incandescent lamp has a temperature of 2000k. calculate the fraction of radiation emitted in the visible light band if the filament is approximated as blackbody

Answers: 2

continue

Engineering, 04.07.2019 18:20, cxttiemsp021

Atank with constant volume contains 2.27 kg of a mixture of water phases (liquid-vapor). in the initial state the temperature and the quality are 127 °c and 0.6, respectively. the mixture is heated until the temperature of 160 oc is reached. illustrate the process in a t-v diagram. then, determine (1) the mass of the vapor in kg at the initial state, (2) the final pressure in kpa.

Answers: 3

continue

Engineering, 04.07.2019 19:10, Destinationz

Asteam is contained in a rigid tank with a volume of 1 m3. initially, the pressure and temperature are 7 bar and 500 oc, respectively. the temperature drops due to cooling process. determine: (1) the temperature at which condensation begins in °c, (2) the fraction of the total mass that has condensed when the pressure decreased to 0.5 bar. (3) the volume in m3 occupied by saturated liquid at the final state?

Answers: 3

continue

Engineering, 06.07.2019 02:30, cofran

A75mm diameter shaft is supported in a journal bearing 75mm long with a diametral clearance of 0. 1mm. it supports a radial load of 1000 n and is lubricated with sae 50 oil at 70°c. find the friction torque and the power loss when the crankshaft rotates at 2900 rev/min.

Answers: 1

continue

Do you know the correct answer?

Match each scenario with the term it represents. As an engineer designs a new truck, he creates a m...