Engineering
Engineering, 03.09.2020 01:01, savrosed

As discussed, the enzyme HIV-1 reverse transcriptae (HIV-RT) plays a significant role for the HIV virus and is an important drug target. Assume a concentration E of 2.00 HM (.e. 2.00 x 106 moln) for HIV-RT. Two potential drug molecules, D1 and D2, were identified, which form stable complexes with the HIV-RT. The dissociation constant of the complex ED, formed by HIV-RT and the drug D is 1.00 nM (G. e. 1.00 x 109). The dissociation constant of the complex ED2 formed by HIV-RT and the drug D2 is 100 nM (i. e. 1.00 x 107)1. Compute the total concentration of [D1] that is needed to bind 90% of the HIV-RT at the given concentration [E] total. 2. Compute the total concentration of [D1] that is needed to bind 99% of the HIV-RT at the given concentration [E] total.3. Compute the total concentration of [D2] that is needed to bind 90% of the HIV-RT at the given concentration [E] total. 4. Compute the total concentration of [D2] that is needed to bind 99% of the HIV-RT at the given concentration [E] total.

answer
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 19:20, holaadios222lol
Apiping systems consists of 6 m of 6-std type k and 12 m of 4-std type k, both drawn copper tubing. the system conveys ethylene glycol at a rate of 0.013 m3/s. the pressure drop across the system is to be calculated. there are two 90° elbows in the 6-in pipe, a reduction from the 6-in pipe to the 4-in pipe and four 90° elbows in the 4-in pipe. all fittings are soldered (same as flanged) and regular. the inlet and outlet of the system are at the same height.
Answers: 1
image
Engineering, 04.07.2019 19:20, mercedesamatap21hx0
To design a steam turbine to produce 12,000 hp power. a engineer comsiders using a steady state stean low st 1160fr and engineer considers using a steady state steam flow at 1160°r and 450 psia to drive this steam turbine. the exhaust of the steam is cooled by the lake (vacuum). heat losing to the surroundings is measured at a rate of 555.55 btu/s. (a) sketch the system with the given conditions. (b) neglecting kinetic and potential energy changes from inlet to exit, determine the volumetric flow rate of the steam at the inlet, (ft'/hr). must clearly show unit conversions at crtical terms.
Answers: 1
image
Engineering, 04.07.2019 19:20, nikkiebartels
Afan that can provide air speeds up to 60 m/s is to be used in a low-speed wind tunnel with atmospheric air at 35 c. if one wishes to use the wind tunnel to study flat-plate boundary layer behavior up to reynolds numbes of re 10, what is the minimum plate length that should be used? at what distance from the leading edge would transition occur if the critical reynolds nurnber were rer, e = 5 × 105?
Answers: 2
image
Engineering, 06.07.2019 03:30, Scotdouglas346
Acubic shaped box has a side length of 1.0 ft and a mass of 10 lbm is sliding on a frictionless horizontal surface towards a 30 upward incline. the horizontal velocity of the box is 20 ft/s. determine how far up the incline the box will travel (report center of mass distance along the inclined surface, not vertical distance)
Answers: 1
Do you know the correct answer?
As discussed, the enzyme HIV-1 reverse transcriptae (HIV-RT) plays a significant role for the HIV vi...

Questions in other subjects: