Engineering, 11.04.2020 03:02, jarvinmcgillp3dhni

A rigid tank with a volume of 4 m^3 contains argon at 500 kPa and 30 deg C. It is connected to a piston cylinder (initially empty) with a line and a closed valve. The pressure in the cylinder should be 300 kPa to float the piston. Now the valvle is slowly opened and heat is transferred so the argon reaches a final state of 30 deg C with the valve open. The heat transfer takes place from a 60 deg C space through a conduction layer 1 cm thick with a conductivity k = 0.1 W/mK and a surface area of 1.5 m^2.

a. Find the final volume of the argon and the total work for the process.

b. Find the total heat transfer needed.

c. How long will the process take?

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, theamandawhite

Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.

Answers: 1

continue

Engineering, 04.07.2019 18:10, niyawilliams23

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

continue

Engineering, 04.07.2019 18:10, sarahgrindstaff123

Afluid flows with a velocity field given by v=(x/t)i.. determine the local and convective accelerations when x=3 and t=1.

Answers: 2

continue

Engineering, 04.07.2019 18:10, bckyanne3

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

continue

Do you know the correct answer?

A rigid tank with a volume of 4 m^3 contains argon at 500 kPa and 30 deg C. It is connected to a pis...