Engineering, 07.04.2020 23:41, destinybonmer

15 cm × 15 cm circuit boarddissipating 20 W of power uniformly is cooled by air, which approached the circuit board at 20C with a velocity of 6 m/s. Assume the flow to be turbulent, since the electronic components are expected to act as turbulators. Disregard any heat transfer from the back surface of the board, and suppose that radiation heat transfer is negligible. Evaluate thermal properties of the air at a film temperature of 27C. Determine the surface temperature (C) of the electronic components at the following locati

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, soreese02

An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature

Answers: 2

continue

Engineering, 06.07.2019 02:30, emiller6462

Plot schematically the tensile stress versus strain curves for a typical thermoplastic material at a temperature below its glass transition temperature (tg and at a temperature above its tg, respectively. do the same for a typical thermosetting material. list in a table any differences or similarities between the two materials at t> tg and t < tg, respectively, and relate them to the structures of the two types of polymers

Answers: 3

continue

Engineering, 06.07.2019 03:20, Giabear23

Major ingredients of traditional ceramics (a) silica (b) clay (c) feldspar (d) all

Answers: 1

continue

Engineering, 06.07.2019 03:30, relic7391

The load on a bolt consists of an axial pull of 10 kn together with a transverse shear force of 5 kn. the bolt material has a yield strength of syt syc 100 mpa. find the diameter of the bolt at factor of safety n-0.5, n 1 and n-2 using maximum shear stress theory

Answers: 3

continue

Do you know the correct answer?

15 cm × 15 cm circuit boarddissipating 20 W of power uniformly is cooled by air, which approached th...