Engineering, 12.02.2020 02:26, whattag

A dc motor is to be started from rest. Jm = 0.02 kg•m2, Ra = 0.35 Ω, and La ≈ 0, Kb = 0.5 N·m/A, and no rotational loss. The motor is driving a load with Jm = 0.04 kg•m2 , and a load torque of 2 N·m. The motor current must not exceed 15 A. Calculate and plot the voltage, Vt, which must be applied to bring this motor to a steady-state speed of 300 rad/sec as quickly as possible, and speed, as functions of time.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 23:20, abbz13

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

continue

Engineering, 04.07.2019 18:10, mm016281

What difference(s) did you notice using a pneumatic circuit over hydraulic circuit. explain why the pneumatic piston stumbles when it hits an obstacle.

Answers: 2

continue

Engineering, 04.07.2019 18:10, niicoleassssssf

Aflywheel accelerates for 5 seconds at 2 rad/s2 from a speed of 20 rpm. determine the total number of revolutions of the flywheel during the period of its acceleration. a.5.65 b.8.43 c. 723 d.6.86

Answers: 2

continue

Engineering, 04.07.2019 18:10, alyssabailey7545

Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines

Answers: 1

continue

Do you know the correct answer?

A dc motor is to be started from rest. Jm = 0.02 kg•m2, Ra = 0.35 Ω, and La ≈ 0, Kb = 0.5 N·m/A, and...