Engineering, 30.11.2019 05:31, rebekahhenton

Assign newmatrixa with origmatrixa, then remove row delrow and column delcol from newmatrixa. assign deletedelems with the deleted row and column values. ex: if origmatrixa is [1, 3, 2; 4, 9, 5; 6, 7, 8; ], delrow is 1, and delcol is 2, then newmatrix a is [ 4, 5; 6, 8; ], and deletedelems is [ 1; 3; 2; 9; 7; 8]

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:20, ashleyjaslin

Derive the correction factor formula for conical nozzle i=-(1+ cosa) and calculate the nozzle angle correction factor for a nozzle whose divergence hal-fangle is 13 (hint: assume that all the mass flow originates at the apex of the cone.

Answers: 3

continue

Engineering, 04.07.2019 18:20, rbgrh9465

An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.

Answers: 3

continue

Engineering, 06.07.2019 02:30, cofran

A75mm diameter shaft is supported in a journal bearing 75mm long with a diametral clearance of 0. 1mm. it supports a radial load of 1000 n and is lubricated with sae 50 oil at 70°c. find the friction torque and the power loss when the crankshaft rotates at 2900 rev/min.

Answers: 1

continue

Engineering, 06.07.2019 03:10, liliauedt

Explain the strain-hardening phenomenon on the basis of dislocation - dislocation strain field interactions. also, briefly describe what generally happens to the ductility of a metal that has been strain hardened (i. e. does strain hardening make a metal more ductile or

Answers: 3

continue

Do you know the correct answer?

Assign newmatrixa with origmatrixa, then remove row delrow and column delcol from newmatrixa. assign...