Your boss asks you to design a room that can be as soundproof as possible and provides you with three samples of material. the only information on each sample's label is the material's coefficient of absorption. the coefficient of absorption listed on sample a is 30%, on sample b is 47%, and on sample c is 62%. when your boss asks for your choice and the reasoning behind it, what would you tell him? a. sample c would be best, because the percentage of the energy in an incident wave that remains in a reflected wave from this material is the smallest. b. sample a would be best, because the percentage of the energy in an incident wave that remains in a reflected wave from this material is the largest. c. sample c would be best, because the percentage of the energy in an incident wave that remains in a reflected wave from this material is the largest. d. sample a would be best, because the percentage of the energy in an incident wave that remains in a reflected wave from this material is the smallest.
Answers: 2
Other questions on the subject: Physics
Physics, 22.06.2019 02:10, allytrujillo20oy0dib
How is coal extracted from mountaintop removal mines? a. dynamite is used to create underground tunnels where miners go to extract the coal. b. dynamite is used to break apart rocks and then draglines are used to remove the broken rock and reach the coal. c. coal in mountaintops is extracted by digging strips in the landscape to reach the coal. d. placer deposits in mountain river bottoms are removed by
Answers: 2
Physics, 22.06.2019 06:30, mehokkj
Alead ball is dropped into a lake from a diving board 5m above the water . it hits the water with a certain velocity and then sink with constant velocity in bottom . it reaches the bottom 5 second after it is dropped if g= 10m/s2 . find depth of the lake and average velocity of the ball ?
Answers: 1
Physics, 22.06.2019 19:50, naidaisha18
Ahuge (essentially infinite) horizontal nonconducting sheet 10.0 cm thick has charge uniformly spread over both faces. the upper face carries +95.0 nc/m2 while the lower face carries -25.0 nc/ m2. what is the magnitude of the electric field at a point within the sheet 2.00 cm below the upper face? (ε0 = 8.85 × 10-12 c2/n · m2)
Answers: 1
Physics, 22.06.2019 21:50, gshreya2005
Which component is used to measure the current in a circuit? oa. switch ob. resistor oc. ammeter the answer is c. for y’all plato people
Answers: 1
Do you know the correct answer?
Your boss asks you to design a room that can be as soundproof as possible and provides you with thre...
Questions in other subjects:
Mathematics, 02.05.2021 02:10
English, 02.05.2021 02:10
