Askydiver of mass m jumps from a hot air balloon and falls a distance d before reaching a terminal velocity of magnitude v. assume that the magnitude of the acceleration due to gravity is g. part a what is the work wd done on the skydiver, over the distance d, by the drag force of the air? express the work in terms of d, v, m, and the magnitude of the acceleration due to gravity g.

Which is special about a dc circuit ? a. it has both series and parallel components b. it has only series or only parallel components c. charge moves in a single direction d. charge moves back and forth quickly

Aparticle of mass m is placed in a one-dimensional box of length l. the box is so small that the particle’s motion is relativistic, so that e p2/2m is not valid. (a) derive an expression for the energy levels of the particle using the relativistic energy–momentum relation and the quantization of momentum that derives from connement. (b) if the particle is an electron in a box of length l 1.00 1012 m, nd its lowest possible kinetic energy. by what percent is the nonrelativistic formula for the energy in error?

Atension test was conducted on a specimen of aisi 1020 hot-rolled steel having an initialdiameter of 9.11 mm. representative test data are given in table1in the form of force and engineering strain. for strain the extensometer gage length was li= 50.8 mm. in addition, minimumdiameters were measuredmanually with a micrometer in the necked region at several points during the test. after fracture, thebroken halves were reassembled, and the following measurements were made: (1) marks originally 25.4 mm apart and on opposite sides of the necked regionwere 38.6 mm apart due to the lengthwise stretching in the specimen; (2) similar marks originally 50.8 mm apart were 70.9 mmapart; (3) the final minimum diameter in the necked region was 5.28 mma) determine the following material properties: elastic modulus, 0.2% offset yield strength, ultimate tensile strength, percent elongation, and percent reduction in area. b) assume that the test was interrupted upon reaching a strain u = 0.007, and the specimen unloaded to zero force. estimate the elastic strain recovered and the plastic strain remaining. also, what would the new length of the original 50.8 mm gage section. hint: might save time/effort to use excel, mathcad, matlab, etc. to solve part a)table1 data and analysis for a tension test on aisi 1020 hot-rolled steeltest dataforce (p, kn)1. 0.002. 6.673. 13.344. 19.135. 17.796. 17.217. 17.538. 17.449. 17.2110. 20.7711. 24.2512. 25.7113. 25.7514. 25.0415. 23.4916. 21.3517. 18.9018. 17.39engr. strain (ε)1. 02. 0.00053. 0.00104. 0.00155. 0.00236. 0.00317. 0.00508. 0.00709. 0.010010. 0.049011. 0.125012. 0.218013. 0.234014. 0.306015. 0.330016. 0.348017. 0.360018. 03660diameter (d, mm)1. 9.112. 9.113. 9.114. 9.115. 9.116. 9.117. 9.118. 9.119. 9.1110. 8.8911. 8.8912. 8.2613. 8.2614. 7.6215. 6.9916. 6.3517. 5.7218. 5.28