Asoccer player practices kicking the ball into the goal from halfway down the soccer field. the time it takes for the ball to get to the goal from the time it is kicked averages about three seconds. the soccer field is 90 meters long. the player wants to know the average velocity of the ball. is there enough information to calculate this? a) no, only average speed can be calculated from the distance of 90 meters and the time of three seconds. b) yes, displacement is 45 meters, elapsed time is three seconds, and the direction is toward the goal. c) no, only average speed can be calculated from the distance of 45 meters and the time of three seconds. d) yes, displacement is 90 meters, elapsed time is three seconds, and the direction is toward the goal.

This is correct, I just did the test. Yes, displacement is 45 meters, elapsed time is three seconds, and the direction is toward the goal.

b

Explanation:

i took the test

d. learned preferences i believe is your answer

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).