You make a u turn in your car, what provides the centripetal force on the car and on you

The correct answer is the frictional force.

In fact, the centripetal force is the force that keeps the car in circular motion, and it points toward the centre of the circular trajectory. The frictional force between the tyres of the car and the road provides the centripetal force that keeps the car in the turn: in fact, without the friction (e.g. on an icy road), the car would not be able to make the turn at the same speed.

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).

0.863333

86%

hope this