Answers: 1
Other questions on the subject: Physics
Physics, 22.06.2019 20:50, dorkygirl
An ideal otto cycle has a compression ratio of 8. at the beginning of the compression process, air is at 95 kpa and 27°c, and 750 kj/kg of heat is transferred to air during the constant-volume heat-addition process. assuming constant specific heats at room temperature, determine (a) the pressure and temperature at the end of the heat-addition process, (b) the net work output, (c) the thermal efficiency, and (d) the mean effective pressure for the cycle. (4390 kpa, 1730 k; 423 kj/kg; 56.4%; 534 kpa)
Answers: 1
Physics, 23.06.2019 02:30, mjam85877
Two 1.20-m nonconducting wires meet at a right angle. one segment carries + 2.50 µc of charge distributed uniformly along its length, and the other carries - 2.50 µc distributed uniformly along it, as shown in fig. 21.50. ( a. find the magnitude and direction of the electric field these wires produce at point p, which is 60.0 cm from each wire. ( b. if an electron is released at p, what are the magnitude and direction of the net force that these wires exert on it?
Answers: 3
Physics, 23.06.2019 15:00, devontadunn4789
Basilisk lizards can run across the top of a water surface (see the figure). with each step, a lizard first slaps its foot against the water and then pushes it down into the water rapidly enough to form an air cavity around the top of the foot. to avoid having to pull the foot back up against water drag in order to complete the step, the lizard withdraws the foot before the water can flow into the air cavity. if the lizard is not to sink, the average upward impulse on the lizard during this full action of slap, downward push, and withdrawal must match the downward impulse due to the gravitational force. suppose the mass of a basilisk lizard is 93.7 g, the mass of each foot is 3.37 g, the speed of a foot as it slaps the water is 1.15 m/s, and the time for a single step is 0.531 as. (a) what is the magnitude of the impulse on the lizard during the slap
Answers: 3
Do you know the correct answer?
In order for combustion to occur what needs to happen...
Questions in other subjects:
