Physics, 30.07.2019 17:00, katrinajernae8216

C' a brother what important safety precaution must be observed when measuring resistance in an electronic circuit? a. the black test lead must be connected to the chassis ground. b. the red test lead must be at the most positive point in the circuit. c. the meter's highest resistance range setting should be used until the actual value is determined. d. all power to the component under test must be disconnected.

Answers: 1

Show answers

Other questions on the subject: Physics

Physics, 21.06.2019 22:10, Tabithaharjo6

Which fators influence ocean currents

Answers: 1

continue

Physics, 22.06.2019 00:00, anna40794

(science)study the following ocean currents map. an ocean currents map is shown. on the map the locations for san diego, california and savannah, georgia are marked. there is a looping current from the north past san diego and a looping current from the south near savannah which statement is most likely correct about the average temperatures in san diego, california as compared to savannah, georgia? it is higher in savannah because of the cool ocean currents from the south. it is higher in savannah because of the warm ocean currents from the north. it is lower in san diego because of the warm ocean currents from the south. it is lower in san diego because of the cool ocean currents from the north.

Answers: 2

continue

Physics, 22.06.2019 01:00, blesskids600

An incident ray through the focal point of a spherical mirror will: reflect through the center of curvature. reflect back through the focal point. reflect parallel to the principle axis. reflect the same direction as the incident ray.

Answers: 1

continue

Physics, 22.06.2019 11:20, leandrogarin37p2g5ds

Suppose a diode consists of a cylindrical cathode with a radius of 6.200×10^−2 cm , mounted coaxially within a cylindrical anode with a radius of 0.5580 cm . the potential difference between the anode and cathode is 260 v . an electron leaves the surface of the cathode with zero initial speed (v initial=0). find its speed vfinal when it strikes the anode.

Answers: 1

continue

Do you know the correct answer?

C' a brother what important safety precaution must be observed when measuring resistance in an ele...