Discuss how the following factors could influence the value of velocity you get in Part A: poor timing accuracy by the photogates, poor release of cart giving it an initial velocity (up or down the track), and error in your measurement of the photogate separation distance. Write out your answer in a clear and well supported paragraph. erase this and type in your answer 2) In this experiment, you calculated the average speed of the cart using the time between two photogates. Is it possible to calculate the speed of the cart using only one photogate

Suppose that two tanks, 1 and 2, each with a large opening at the top, contain different liquids. a small hole is made in the side of each tank at the same depth 1.57 m below the liquid surface, but the hole in tank 2 has 2.49 times the cross-sectional area of the hole in tank 1. (a) what is the ratio ρ1/ρ2 of the densities of the liquids if the mass flow rate is the same for the two holes? (b) what is the ratio rv1/rv2 of the volume flow rates from the two tanks? (c) at one instant, the liquid in tank 1 is 14.9 cm above the hole. if the tanks are to have equal volume flow rates, what height above the hole must the liquid in tank 2 be just then?

Atotal charge of –6.50 µc is uniformly distributed within a sphere that has a radius of 0.150 m. what is the magnitude and direction of the electric field at 0.300 m from the surface of the sphere? a) 2.89 × 105 n/c, radially inward b) 6.49 × 105 n/c, radially outward c) 4.69 × 105 n/c, radially inward d) 9.38 × 105 n/c, radially outward e) 1.30 × 106 n/c, radially inward

What is the average speed of a car that travels 40mph for 1 hour and 60 mph in another hour will mark brainliest