Physics
Physics, 11.02.2022 14:00, mathisaqeosmw

The length and width of each plate of a parallel plate capacitor are doubled, and the spacing between the plates is also doubled. By what factor does the capacitance change?.

answer
Answers: 2

Other questions on the subject: Physics

image
Physics, 21.06.2019 22:00, baileysosmart
Jason and mia are both running in a race. as they approach the finish line, you being the physicist that you are decide to time how long it takes them to reach the end of the race. when you start your stop watch (you can take this as time t = 0 s) you notice that mia is an unknown distance d ahead of jason and both are moving with the same initial velocity v_0. you also notice that jason is accelerating at a constant rate of a_j, while mia is deaccelerating at a constant rate of -a_m. jason and mia meet each other for the first time at time t = t_1. at this time (t = t_1) jason's velocity is two times that of mia's velocity, meaning v_j (t_1) = 2v_m (t_1). a) draw the position vs. time graph describing mia's and jason's motion from time t = 0 to time t = t_1. clearly label your axes and initial conditions on your graph. b) draw the velocity vs. time graph describing mia and jason's motion from time t = 0s to time t = t_1. clearly label your axes and initial conditions on your graph. c) how long from when the stop watch was started at t = 0s did it take mia and jason to meet? express your answer in terms of know quantities v_0, a_m, and a_j. d) when the stop watch started at time t = 0s, how far apart, d, were mia and jason? express your answer in terms of know quantities v_0, a_m, and a_j.
Answers: 1
image
Physics, 22.06.2019 05:20, deedee363
Given the position vector of the particle r(t)=(t+1)i+(t^2βˆ’1)j+2t k, find the particle's velocity and acceleration vectors at t=1
Answers: 1
image
Physics, 22.06.2019 12:30, dai77
An object resting on a table weighs 100 n. with what force is the object pushing on the table? with what force is the table pushing on the object? explain how you got your answer.
Answers: 2
image
Physics, 23.06.2019 07:00, Fireburntbudder
Your physics assignment is to figure out a way to use electricity to launch a small 6.0-cm-long plastic drink stirrer. you decide that you'll charge the little plastic rod by rubbing it with fur, then hold it near a long, charged wire, as shown in figure p23.56 . when you let go, the electric force of the wire on the plastic rod will shoot it away. suppose you can uniformly charge the plastic stirrer to 10 nc and that the linear charge density of the long wire is 1.0 x10-7 c/m. what is the net electric force on the plastic stirrer if the end closest to the wire is 2.0 cm away?
Answers: 1
Do you know the correct answer?
The length and width of each plate of a parallel plate capacitor are doubled, and the spacing betwee...

Questions in other subjects:

Konu
Mathematics, 09.06.2021 06:10