When comparing the momentum of two moving objects, which of the following is correct?

Part f - example: finding two forces (part i) two dimensional dynamics often involves solving for two unknown quantities in two separate equations describing the total force. the block in (figure 1) has a mass m=10kg and is being pulled by a force f on a table with coefficient of static friction îľs=0.3. four forces act on it: the applied force f (directed î¸=30â above the horizontal). the force of gravity fg=mg (directly down, where g=9.8m/s2). the normal force n (directly up). the force of static friction fs (directly left, opposing any potential motion). if we want to find the size of the force necessary to just barely overcome static friction (in which case fs=îľsn), we use the condition that the sum of the forces in both directions must be 0. using some basic trigonometry, we can write this condition out for the forces in both the horizontal and vertical directions, respectively, as: fcosî¸â’îľsn=0 fsinî¸+nâ’mg=0 in order to find the magnitude of force f, we have to solve a system of two equations with both f and the normal force n unknown. use the methods we have learned to find an expression for f in terms of m, g, î¸, and îľs (no n).

Immediately upon reaching its lowest point, a falling pendulum bob has its greatest amount of energy, which is the initial amount of potential energy. a. heat; less than b. heat; more than c. kinetic; less than d. kinetic; more than

The space between two 15-in.-long concentric cylinders is filled with glycerin (viscosity = 8.5 × 10-3 lb·s/ft2). the inner cylinder has a radius of 1 in. and the gap width between cylinders is 0.1 in. determine (a) the torque and (b) the power required to rotate the inner cylinder at 180 rev/min. the outer cylinder is fixed. assume the velocity distribution in the gap to be linear.