Physics
Physics, 27.10.2021 18:00, pinapunapula

on a a mile A tensile test was conducted steel bar The following was obtained Diameter of steel bar 2 cm Gauge tength of the bar 200m Load clastic limit 200,000 N Extension of a load of isokln 15 0.18 m is maximum load 350k IN Total extension 50mm Diameter of the load atfallure is lisch determine as The b.) The s youngs modulus

answer
Answers: 2

Other questions on the subject: Physics

image
Physics, 22.06.2019 05:10, zionnahl
Total solidification times of three casting geometries are to be compared: a sphere, a cylinder, in which the length-to-diameter ration - 1.0, and a cube. volume = 1000 cm^3 for all three shhapes, and the same casting alloy is used. a) determine the solidification times of each geometry b) based on the results of part (a), which geometric element would make the best riser? c) if the mold constant = 3.5 min/cm^2 in chvorinov's rule, compute the total solidification time for each casting.
Answers: 3
image
Physics, 22.06.2019 05:30, ellycleland16
Iwill give 30 points to whoever answers ! what is the formula for actual mechanical advantage and ideal mechanical advantage?
Answers: 1
image
Physics, 22.06.2019 09:00, atsuedem974
Chemical energy is a form of energy. a. heat b. kinetic c. potential d. electromagnetic
Answers: 2
image
Physics, 22.06.2019 17:00, cwibs
Adiver named jacques observes a bubble of air rising from the bottom of a lake (where the absolute pressure is 3.50 atm) to the surface (where the pressure is 1.00 atm). the temperature at the bottom is 4.00 ∘c, and the temperature at the surface is 23.0 ∘c. what is the ratio of the volume of the bubble as it reaches the surface (vs) to its volume at the bottom (vb)? if jaques were to hold his breath the air in his lungs would be kept at a constant temperature. would it be safe for jacques to hold his breath while ascending from the bottom of the lake to the surface?
Answers: 1
Do you know the correct answer?
on a a mile A tensile test was conducted steel bar The following was obtained Diameter of steel bar...

Questions in other subjects: