In the figure of this exercise a block is shown, initially located at rest at a height d = 40cm on a ramp It has horizontal zones and sloped zones. It is known that in inclined areas, the coefficient of kinetic friction between
the block and the surface is negligible; while in the horizontal zones, the coefficient of kinetic friction between the block
and the surface is µk = 0.5.

Determine where the block stops (momentarily or indefinitely). If the block stops on a surface
horizontal, determine the distance L traveled on the horizontal surface. If the block reaches the ramp,
Determine the height H (measured above the lowest horizontal surface) that the block reaches.

Part a determine the magnitude of the x component of f using scalar notation. fx f x = nothing lb request answer part b determine the magnitude of the y component of f using scalar notation. fy f y = nothing lb request answer part c determine the magnitude of the z component of f using scalar notation. fz f z = nothing lb request answer provide feedback figure1 of 1a force vector acting on a ring attached to the ground is shown in the xyz space together with its x, y, and z components lying on the corresponding positive axes. the ring is located at the origin. force f is located in the first octant. f makes an angle of 60 degrees with its x component and an angle of 45 degrees with its y component. a force vector acting on a ring attached to the ground is shown in the xyz space together with its x, y, and z components lying on the corresponding positive axes. the ring is located at the origin. force f is located in the first octant. f makes an angle of 60 degrees with its x component and an angle of 45 degrees with its y component.

Which is not a characteristic of a heat pump? a. it is used in air conditioners. b. it uses a refrigerant. c. it requires no work. d. it reverses the normal flow of thermal energy.

It may seem strange that the selected velocity does not depend on either the mass or the charge of the particle. (for example, would the velocity of a neutral particle be selected by passage through this device? ) the explanation of this is that the mass and the charge control the resolution of the device--particles with the wrong velocity will be accelerated away from the straight line and will not pass through the exit slit. if the acceleration depends strongly on the velocity, then particles with just slightly wrong velocities will feel a substantial transverse acceleration and will not exit the selector. because the acc