Physics
Physics, 05.10.2021 14:10, tammydbrooks43

Each strip in the tape chart of the chart above is for a time interval of 1 tentick.

1. if the timer makes 50 dots per second, what time
intervals are represented by OA and AB?

2. What is the acceleration between 0 and A in
(i) cm/tentick?
(ii) cm/s per tentick,
(iii) cm/s2?

3.What is the acceleration between A and B?

answer
Answers: 1

Other questions on the subject: Physics

image
Physics, 22.06.2019 09:00, jaeana
Abicycle slows down when the rider applies the brakes. what type of energy transformation is involved in this example? a. kinetic energy into heat energy b. heat energy into potential energy c. potential energy into kinetic energy d. kinetic energy into mechanical energy
Answers: 1
image
Physics, 22.06.2019 10:50, afonseca73
Asheet of steel 1.5 mm thick has nitrogen atmospheres on both sides at 1200oc and is permitted to achieve a steady-state diffusion condition. the diffusion coefficient for nitrogen in steel at this temperature is 6 x 10- 11 m2 /s, and the diffusion flux is found to be 1.2 x 10-7 kg/m2 -s. also, it is known that the concentration of nitrogen in the steel at the high-pressure surface is 4 kg/m3 . how far into the sheet from this high-pressure side will the concentration be 2.0 kg/m3 ? assume a linear concentration profile.
Answers: 3
image
Physics, 22.06.2019 14:20, jeny89
4r-134a enters the condenser of a residential heat pump at 800 kpa and 50°c at a rate of 0.022 kg/s and leaves at 750 kpa subcooled by 3°c. the refrigerant enters the compressor at 200 kpa superheated by 4°c determine (a) the isentropic efficiency of the compressor, (b) the rate of heat supplied to the heated room, and (c) the cop of the heat pump. also, determine (d) the cop and rate of heat supplied to the heated room if this heat pump operated on the ideal vapor-compression cycle between the pressure limits of 200 and 800 kpa. (0.757, 4.37 kw, 5.12, 6.18, 3.91 kw)
Answers: 3
image
Physics, 22.06.2019 14:30, gus2006santos
Two steel balls, each of mass m, are welded to a light rod of length l and negligible mass and are initially at rest on a smooth horizontal surface. a horizontal force of magnitude f is suddenly applied to the rod as shown. determine (a) the instantaneous acceleration a of the mass center g and (b) the corresponding rate at which the angular velocity of the assembly about g is changing with time.
Answers: 2
Do you know the correct answer?
Each strip in the tape chart of the chart above is for a time interval of 1 tentick.

1....

Questions in other subjects:

Konu
Mathematics, 26.03.2020 07:57
Konu
Social Studies, 26.03.2020 07:59