Set up the experiment as follows:
1. Make a small hole in the cardboard. It should be 4 inch from one edge and centered.
2. Pull the string or thread through the hole in the cardboard, and tie the ends together to form a loop.
3. Slide a large paperclip onto the string, and bend one end out slightly to act as a hook.
4. Place a nonbreakable object, such as a kitchen utensil, on the cardboard.
5. Select two nonbreakable objects with holes that can be hung on the hook.
What two objects will you select to hang on the hook?
Answers: 3
Physics, 21.06.2019 22:00, baileysosmart
Jason and mia are both running in a race. as they approach the finish line, you being the physicist that you are decide to time how long it takes them to reach the end of the race. when you start your stop watch (you can take this as time t = 0 s) you notice that mia is an unknown distance d ahead of jason and both are moving with the same initial velocity v_0. you also notice that jason is accelerating at a constant rate of a_j, while mia is deaccelerating at a constant rate of -a_m. jason and mia meet each other for the first time at time t = t_1. at this time (t = t_1) jason's velocity is two times that of mia's velocity, meaning v_j (t_1) = 2v_m (t_1). a) draw the position vs. time graph describing mia's and jason's motion from time t = 0 to time t = t_1. clearly label your axes and initial conditions on your graph. b) draw the velocity vs. time graph describing mia and jason's motion from time t = 0s to time t = t_1. clearly label your axes and initial conditions on your graph. c) how long from when the stop watch was started at t = 0s did it take mia and jason to meet? express your answer in terms of know quantities v_0, a_m, and a_j. d) when the stop watch started at time t = 0s, how far apart, d, were mia and jason? express your answer in terms of know quantities v_0, a_m, and a_j.
Answers: 1
Physics, 22.06.2019 05:10, zionnahl
Total solidification times of three casting geometries are to be compared: a sphere, a cylinder, in which the length-to-diameter ration - 1.0, and a cube. volume = 1000 cm^3 for all three shhapes, and the same casting alloy is used. a) determine the solidification times of each geometry b) based on the results of part (a), which geometric element would make the best riser? c) if the mold constant = 3.5 min/cm^2 in chvorinov's rule, compute the total solidification time for each casting.
Answers: 3
Physics, 22.06.2019 15:30, tiffuuu
At 20βc, the hole in an aluminum ring is 2.800 cm in diameter. you need to slip this ring over a steel shaft that has a room-temperature diameter of 2.804 cm . 1. to what common temperature should the ring and the shaft be heated so that the ring will just fit onto the shaft? coefficients of linear thermal expansion of steel and aluminum are 12Γ10β6 kβ1 and23Γ10β6 kβ1 respectively.
Answers: 1
Set up the experiment as follows:
1. Make a small hole in the cardboard. It should be 4 inch from...
Physics, 30.01.2020 23:03
Mathematics, 30.01.2020 23:03
Biology, 30.01.2020 23:03
Mathematics, 30.01.2020 23:03
Social Studies, 30.01.2020 23:03
English, 30.01.2020 23:03