Physics
Physics, 28.08.2021 01:20, genaro19

Rachel measured the mass of an empty 250cm3 flask. She then filled the flask with a gas of unknown molar mass at an atmospheric pressure of 100kPa and a temperature of 27 degrees. She found that the mass of the flask and contents increased by 0.44 g. Calculate the molar mass of the gas Rachel used to fill the flask​

answer
Answers: 3

Other questions on the subject: Physics

image
Physics, 21.06.2019 16:00, amoakoh800003
As shown in fig. p3.64, a closed, rigid tank fitted with a fine-wire electric resistor is filled with refrigerant 22, initially at 2108c, a quality of 80%, and a volume of 0.01 m3. a 12-volt battery provides a 5-amp current to the resistor for 5 minutes. if the final temperature of the refrigerant is 408c, determine the heat transfer, in kj, from the refrigerant.
Answers: 1
image
Physics, 21.06.2019 22:30, droidd133
Fft review: linspace, fs, fftshift, nfft 1. generate one second of a cosine of w,-10hz sampled at f, = 100hz and assign it to x. define a tt as your time axis 2. take 64 points fft. 3. as you remember, the dft (which the fft implements) computes n samples of s2t where k-0,1,2, n -1. plot the magnitude of this 64-points fft at range 0 to 63, what do you think of this graph? 4â·to get the x-axis into a hz-frequency form, plot this 64-points fft between-50 to 50 (the 100hz sampling rate) and have n-points between them. 5. according to your figure, what frequency is this cosine wave at? 6. remember that the fft is evaluating from 0 to 2ď€. we are used to viewing graphs from-ď€ to ď€. therefore, you need to shift your graph. 7. now according to your shifted graph. what frequency is this at? 8. note that the spikes have long drop-offs? try a 1024-point dft. note that the peak is closer to 10 and the drop-off is quicker. although, now sidelobes are an issue
Answers: 2
image
Physics, 22.06.2019 05:00, unknowntay04
He viscosities of several liquids are being compared. all the liquids are poured down a slope with equal path lengths. the liquid with the highest viscosity will
Answers: 3
image
Physics, 22.06.2019 08:00, booitsmrradl3385
While studying chemical reactions and conservation of matter, sarah's class conducted a variety of experiments. sarah and her lab partner found the mass of a wax candle and placed the candle in a flask. the students lit the candle and let it burn to completion. all that was left was wax and charred candle wick. per their teacher's instructions, the students found the mass of the products. their data can be seen in the data table. formulate a hypothesis the students could test to explain why the experiment did not support the law of conservation of matter. a) the students could repeat the experiment using different candles; there might have been a flaw in the candle. b) the experiment should be repeatable. the students should run several trials and then take an average of the after mass in each trial. c) the students should have someone in the class check their measurement skills as they repeat the experiment. they may have made an error using the balance. d) the students should burn the candle in a container that has some type of lid so that any gas that is a product of the reaction can be contained and massed. submit
Answers: 2
Do you know the correct answer?
Rachel measured the mass of an empty 250cm3 flask. She then filled the flask with a gas of unknown m...

Questions in other subjects:

Konu
Chemistry, 18.02.2021 21:30
Konu
English, 18.02.2021 21:30
Konu
Health, 18.02.2021 21:30