Physics
Physics, 04.08.2021 14:00, RNBWBlight2037

Faraday’s Law
Electric generators use the properties of electromagnetism to transform kinetic energy into electrical energy. Many electric generators work by spinning a permanent magnet near coils of wire. Experiment with this http://contentstore. ple. platoweb. com/content/sharedmedia/sims/farada ys-law/Faraday's%20Electromagnetic% 20Lab. html to visualize how this process works. Once the simulation opens, try moving the permanent magnet around to see what happens. Also rapidly switch the polarity of the magnet by repeatedly clicking on the magnet icon at the bottom of the page, and observe the effect.

Part A
Try moving the magnet in the different ways described in the table below,. Record your observations in the second column of the table.

Part B
After producing electricity in many different ways, describe what causes electricity to flow in the coil? In your response, describe the types of forces acting on the electrons and how they result in movement.


60 POINTS
Faraday’s Law
Electric generators use the properties of electromagn

answer
Answers: 3

Other questions on the subject: Physics

image
Physics, 22.06.2019 01:00, blesskids600
An incident ray through the focal point of a spherical mirror will: reflect through the center of curvature. reflect back through the focal point. reflect parallel to the principle axis. reflect the same direction as the incident ray.
Answers: 1
image
Physics, 22.06.2019 01:30, sdoty7702
Which example has gravitational potential energy? a. a horse slowing down from a run b. an apple about to fall from a tree branch c. a bicycle being pedaled down a horizontal path d. beaker sitting on the floor
Answers: 1
image
Physics, 22.06.2019 14:10, nikki4367
Amachinist turns the power on to a grinding wheel, at rest, at time t = 0 s. the wheel accelerates uniformly for 10 s and reaches the operating angular velocity of 96 rad/s. the wheel is run at that angular velocity for 40 s and then power is shut off. the wheel slows down uniformly at 1.5 rad/s2 until the wheel stops. in this situation, the time interval of deceleration is closest to:
Answers: 3
image
Physics, 22.06.2019 19:30, rprest00
Amass m = 74 kg slides on a frictionless track that has a drop, followed by a loop-the-loop with radius r = 18.4 m and finally a flat straight section at the same height as the center of the loop (18.4 m off the ground). since the mass would not make it around the loop if released from the height of the top of the loop (do you know why? ) it must be released above the top of the loop-the-loop height. (assume the mass never leaves the smooth track at any point on its path.) 1. what is the minimum speed the block must have at the top of the loop to make it around the loop-the-loop without leaving the track? 2. what height above the ground must the mass begin to make it around the loop-the-loop? 3. if the mass has just enough speed to make it around the loop without leaving the track, what will its speed be at the bottom of the loop? 4. if the mass has just enough speed to make it around the loop without leaving the track, what is its speed at the final flat level (18.4 m off the ground)? 5. now a spring with spring constant k = 15600 n/m is used on the final flat surface to stop the mass. how far does the spring compress?
Answers: 3
Do you know the correct answer?
Faraday’s Law
Electric generators use the properties of electromagnetism to transform kinetic...

Questions in other subjects:

Konu
History, 04.10.2021 08:20