Physics
Physics, 05.07.2021 19:10, acervantes29

If water is forced to flow in a level pipe and the pipe diameter gets smaller, the total pressure get: a. smaller
b. larger
c. constant
d. further info required

answer
Answers: 3

Other questions on the subject: Physics

image
Physics, 21.06.2019 17:20, buiratsamah
You have been called to testify as an expert witness in a trial involving a head-on collision. car a weighs 1515 lb and was traveling eastward. car b weighs 1125 lb and was traveling westward at 44.0 mph. the cars locked bumpers and slid eastward with their wheels locked for 22.5 ft before stopping. you have measured the coefficient of kinetic friction between the tires and the pavement to be 0.750 . how fast (in miles per hour) was car a traveling just before the collision? (this problem uses english units because they would be used in a u. s. legal proceeding.)
Answers: 3
image
Physics, 22.06.2019 14:00, Amrinderkhattra
Give an example of a collision in real life. use the law of conservation of energy to describe the transfer of momentum. be sure and discuss the momentum before and after the collision occurs. you will need at least 3 sentences to thoroughly answer this question.
Answers: 1
image
Physics, 22.06.2019 20:40, madisonnnn68
Ablock of mass m = 2.5 kg is attached to a spring with spring constant k = 740 n/m. it is initially at rest on an inclined plane that is at an angle of theta= 26 with respect to the horizontal, and the coefficient of kinetic friction between the block and the plane is uk = 0.17. in the initial position, where the spring is compressed by a distance of d = 0.16 m, the mass is at its lowest position and the spring is compressed the maximum amount. take the initial gravitational energy of the block as zero. the block's initial mechanical energy is 9.472 j. b. if the spring pushes the block up the incline, what distance l in meters will the block travel before coming to rest? the spring remains attached to both the block and the fixed wall throughout its motion.
Answers: 3
image
Physics, 22.06.2019 21:40, iancuteodora30
Ahair dryer is basically a duct in which a few layers of electric resistors are placed. a small fan pulls the air in and forces it through the resistors where it is heated. air enters a 1200 w hair dryer at 100 kpa and 22°c and leaves at 47°c. the cross-sectional area of the hair dryer at the exit is 60 cm2. neglecting the power consumed by the fan and the heat losses through the walls of the hair dryer, determine (a) the volume flow rate of air at the inlet and (b) the velocity of the air at the exit.
Answers: 1
Do you know the correct answer?
If water is forced to flow in a level pipe and the pipe diameter gets smaller, the total pressure ge...

Questions in other subjects:

Konu
History, 23.05.2021 02:30
Konu
Mathematics, 23.05.2021 02:30
Konu
English, 23.05.2021 02:30