Physics
Physics, 03.07.2021 01:20, julian1260

Assuming the atmospheric pressure is 1 atm at sea level, determine the atmospheric pressure at Badwater (in Death Valley, California) where the elevation is 86.0 m below sea level.

answer
Answers: 2

Other questions on the subject: Physics

image
Physics, 21.06.2019 16:30, epunisa
In raising a 6200-n piano with a pulley system, the movers note that, for every 2.2 m of rope pulled down, the piano rises 0.12 m . ideally, find the force required to lift the piano.
Answers: 2
image
Physics, 22.06.2019 09:50, trobbie817
A250-n box is at rest on a frictionless horizotal floor. then a person shoves the box with a non-zero force of magnitude p. which statement best describes the relationship betweeen p and the motion of the box after it was shoved? -the box will not move when p< 250n but otherwise will accelerate at a constant rate that is directly proportional to p - the box will begin moving at a speed that is directly proportional to p, then will gradually slow to a halt -the box will move with constant velocity at a speed that is directly proportional to p -box will accelerate across the floor at a constant rate that is directly proportional to p
Answers: 1
image
Physics, 22.06.2019 14:00, smkw04p3ao0n
If element x has 99 protons how many electrons does it have
Answers: 1
image
Physics, 22.06.2019 14:20, timothyashburn8
Antireflective coatings on solar cells are often made by applying a thin film of silicon nitride (sinx), which has an index of refractive of 1.2, on the top of the silicon solar cell, which has a refractive index of about 3.5. however, the sun emits radiation of various wavelengths which the solar cell absorbs, and the antireflective coating can only absolutely minimize the reflection of one of these wavelengths. the coating thickness is chosen to reduce the reflection of green/yellow light (e = 2.2 ev), which is the most intense color in the solar spectrum (shown below). which of the following coatings would minimize reflection of green/yellow light? the answer is 820 nm how? what is the angular width of the central maximum of an electron traveling at 2 x 108 m/s going through a single slit of width 1 mm.
Answers: 1
Do you know the correct answer?
Assuming the atmospheric pressure is 1 atm at sea level, determine the atmospheric pressure at Badwa...

Questions in other subjects: