Physics, 03.06.2021 20:30, tashaunalewis6774
Part D
Create an outline to organize your paper. Write the outline for your paper in the space provided. Following these guidelines for writing a five-paragraph essay is a good idea. Be sure to account for the claim you’re making about the security and reliability of analog and digital signals in your introduction, and include a works cited page at the end.
100 POINTS FOR A REAL ANSWER
Answers: 2
Physics, 22.06.2019 05:30, trevorhenyan51
Suppose you have three polarizing filters, with the second at an angle of 42∘ to the first and the third at an angle of 90∘ to the first. by what perfect will the original intensity of unpolarized light be reduced to after passing through all three filters?
Answers: 2
Physics, 22.06.2019 06:30, mehokkj
Alead ball is dropped into a lake from a diving board 5m above the water . it hits the water with a certain velocity and then sink with constant velocity in bottom . it reaches the bottom 5 second after it is dropped if g= 10m/s2 . find depth of the lake and average velocity of the ball ?
Answers: 1
Physics, 23.06.2019 02:10, Nathaliasmiles
Find the steady-state temperature at the center of the plate = /2, = /2) for sums of w from n=1 to n=19 (only odd values). find the value of n for which the change in /2, /2) is less than 1% from the value at the previous n. at this point, we consider the solution converged. does the value of the temperature at the center seem reasonable? in this part, the values of x and y are constant scalar values. you should produce a plot of the value of n on the horizontal and the estimate of the temperature at the center of the plate on the vertical. b. using the value of n (or larger) that resulted in convergence in part (a), create a contourf plot of the temperature distribution across the entire plate. use enough spatial subdivisions to create a useful plot. comment on the results. hint: you need to determine what “x” and “y” values to use to make your t matrix. i recommend using a different number of x and y values. use enough x and y values so that the plot is “smooth”.
Answers: 1
Physics, 23.06.2019 11:00, fr996060
The safe load, l, of a wooden beam of width w, height h, and length l, supported at both ends, varies directly as the product of the width and the square of the height, and inversely as the length. a wooden beam 4 inches wide, 9 inches high, and 240 inches long can hold a load of 6810 pounds. what load would a beam 3 inches wide, 8 inches high, and 144 inches long, of the same material, support? (round off your answer to the nearest integer.)
Answers: 1
Part D
Create an outline to organize your paper. Write the outline for your paper in the space prov...
Mathematics, 01.12.2020 22:40
Chemistry, 01.12.2020 22:40
Mathematics, 01.12.2020 22:40
Mathematics, 01.12.2020 22:40