A student is building a model of a lens that will spread light over the biggest space. Which best describes the type of model the student should make? O A The student should make a convex lens model because it directs light away from the center of the lens.
OB. The student should make a concave lens model because it breaks light down into bands of color
c. The student should make a concave lens model because it directs light away from the center of the lens
D. The student should make a convex lens model because it breaks light down into bands of color.

Two horizontal plates with infinite length and width are separated by a distance h in the z direction. the bottom plate is moving at a velocity u. the incompressible fluid trapped between the plates is moving in the positive x-direction with the bottom plate. align gravity with positive z. assume that the flow is fully-developed and laminar. if the systems operates at steady state and the pressure gradient in x-direction can be ignored, do the following: 1. sketch your system 2. identify the coordinate system to be used. 3. show your coordinates and origin point on the sketch. list all your assumptions. 5. apply the continuity equation to your system. nts of navier stokes equations of choice to your system 7. solve the resulting differential equation to obtain the velocity profile within the system make sure to list your boundary conditions. check units of velocity 8. describe the velocity profile you obtain using engineering terminology. sketch that on the same sketch you provided in (1). 9. obtain the equation that describes the volumetric flow rate in the system. check the units.

If angle "a" is 25°, angle "b" is: a) equal to angle c b) less than angle c c) greater than angle c

Arefrigerator uses r-134a as the working fluid and operates on the ideal vapor-compression refrigeration cycle except for the compression process. the refrigerant enters the evaporator at 120 kpa with a quality of 34 percent and leaves the compressor at 70°c. if the compressor consumes 450 w of power, determine (a) the mass flow rate of the refrigerant, (b) the condenser pressure, and (c) the cop of the refrigerator. (0.00644 kg/s, 800 kpa, 2.03)