For a series circuit: а. the value of resistance may be different for each resistor in the circuit.
b. the total resistance is the sum of the resistance in the circuit.
c. the total resistance increases as resistors are added to the circuit.
d. All of the above

Fft review: linspace, fs, fftshift, nfft 1. generate one second of a cosine of w,-10hz sampled at f, = 100hz and assign it to x. define a tt as your time axis 2. take 64 points fft. 3. as you remember, the dft (which the fft implements) computes n samples of s2t where k-0,1,2, n -1. plot the magnitude of this 64-points fft at range 0 to 63, what do you think of this graph? 4â·to get the x-axis into a hz-frequency form, plot this 64-points fft between-50 to 50 (the 100hz sampling rate) and have n-points between them. 5. according to your figure, what frequency is this cosine wave at? 6. remember that the fft is evaluating from 0 to 2ď€. we are used to viewing graphs from-ď€ to ď€. therefore, you need to shift your graph. 7. now according to your shifted graph. what frequency is this at? 8. note that the spikes have long drop-offs? try a 1024-point dft. note that the peak is closer to 10 and the drop-off is quicker. although, now sidelobes are an issue

Awind turbine is rotating counterclockwise at 0.5 rev/s and slows to a stop in 10 s. its blades are 20 m in length. (a) what is the angular acceleration of the turbine? (b) what is the centripetal acceleration of the tip of the blades at t=0s? (c) what is the magnitude and direction of the total linear acceleration of the tip of the blades at t=0s?

This is one type of line graph in which the independent variable is time plotted on the x axis and the dependent variable, also numerical, is plotted on the y axis.