Which of the four thermistors would be the most suitable to measure the surface temperature of the sea?

a solenoid is created by wrapping a l = 90 m long wire around a hollow tube of diameter d = 4.5 cm.   the wire diameter is d = 0.9 mm.   the solenoid wire is then connected to a power supply so that a current of i = 9 a flows through the wire.

randomized variablesl = 90 m

d = 4.5 cm

d = 0.9 mm

i = 9 a                                          

write an expression for the number of turns, n, in the solenoid. you do not need to take into account the diameter of the wire in this calculation.

calculate the number of turns, n, in the solenoid.

write an expression for the length of the solenoid (l2) in terms of the diameter of the hollow tube d.

calculate the length of the solenoid (l2)   in meters.

calculate the magnitude of the magnetic field at the center of the solenoid in teslas.

explanation:

so here is the information for current research:

-nrel's geothermal analysts, scientists, and engineers perform a full range of research from developing advanced methods of locating and accessing geothermal resources to exploring innovative technologies to extract and produce clean energy from the heat of the earth

and here is the information for the technology of geothermal energy:

-it's clean and sustainable

-resources of geothermal energy range from the shallow ground to hot water and hot rock found a few miles beneath the earth's surface, and down even deeper to the extremely high temperatures of molten rock called magma

-almost everywhere, the shallow ground or upper 10 feet of the earth's surface maintains a nearly constant temperature between 50° and 60°f (10° and 16°c)

-geothermal heat pumps can tap into this resource to heat and cool buildings

-a geothermal heat pump system consists of a heat pump, an air delivery system (ductwork), and a heat exchanger-a system of pipes buried in the shallow ground near the building

-in the winter, the heat pump removes heat from the heat exchanger and pumps it into the indoor air delivery system

-in the summer, the process is reversed, and the heat pump moves heat from the indoor air into the heat exchanger

-the heat removed from the indoor air during the summer can also be used to provide a free source of hot water

r = ρ x length / area  

ρ = r x area / length  

ρ is in ohm-meters  

in basic units, it is m³kg/s³a²  

i think this is it.