Physics
Physics, 10.05.2021 17:40, tami5

What happens when the speed at which a magnet moves is increased? a.
Current decreases
c.
The poles of the magnet change
b.
Current increases
d.
The charge dissipates

answer
Answers: 2

Other questions on the subject: Physics

image
Physics, 22.06.2019 05:30, ygrant03
Debbie places two shopping carts in a cart corral she pushes the first cart which then pushes a second cart what force is being exerted
Answers: 1
image
Physics, 23.06.2019 00:40, maggie2018
Researchers conducted an experiment to identify the effects of three different hand sanitizers on the growth of bacteria. the researchers grew one type of bacteria in twenty-four identical covered petri dishes. then, they opened eighteen petri dishes and applied the three hand sanitizers to six petri dishes each. they left the remaining six petri dishes closed as a control group. when the researchers measured the growth of bacteria two days later, the six dishes that had no hand sanitizer showed the least amount of bacterial growth. the researchers concluded that not using any hand sanitizer would lead to the least bacterial growth. which statement best explains why the researchers’ conclusion was not justified? the experiment tested too many variables. the control group was not treated the same as the experimental group. the sample size of twenty-four petri dishes is not large enough. the single type of bacteria is not adequate to make any conclusions.
Answers: 1
image
Physics, 23.06.2019 07:00, hockejoh000
Conventional hot-water heaters consist of a tank of water maintained at a fixed temperature. the hot water is to be used when needed. the drawback is that energy is wasted because the tank loses heat when it is not in use, and you can run out of hot water if you use too much. some utility companies are encouraging the use of on-demand water heaters (also known as flash heaters), which consist of heating units to heat the water as you use it. no water tank is involved, so no heat is wasted. a typical household shower flow rate is 2.50 gal/min (9.46 l/min ) with the tap water being heated from 51.0 ˚f (10.6 ˚c) to 120 ˚f (48.9 ˚c) by the on-demand heater. what rate of heat input (either electrical of from gas) is required to operate such a unit, assuming that all the heat goes into the water?
Answers: 3
image
Physics, 23.06.2019 10:40, therinzler1825
1. study the scenario. the particles in some system are moving around quickly. a few minutes later, the particles are moving, on average, more slowly. how does this change in motion affect the temperature of the system? the temperature of the system did not change. the speed of the particles does not affect temperature, the number of particles affects the temperature. the temperature of the system is lower now than it was initially. faster moving particles result in a higher temperature for the system. the temperature of the system is higher now than it was initially. slower moving particles result in a higher temperature for the system. the temperature of the system did not change. the speed of the particles has no effect on the temperature, only the type of atom affects the temperature.
Answers: 2
Do you know the correct answer?
What happens when the speed at which a magnet moves is increased? a.
Current decreases
...

Questions in other subjects:

Konu
Health, 27.04.2020 01:35