Physics
Physics, 08.05.2021 01:00, iceecole6570

The circumference you found in part A is in inches. To convert the circumference to miles, divide the number of inches by 12 to get the circumference in feet. Then divide that number by 5,280 (there are 5,280 feet in a mile) to get the circumference in miles. This number is the number of miles a cup traveled in one revolution. Multiply this value by the 150 revolutions the cup made in one minute. Then multiply by 60 minutes to get the approximate number of miles per hour. Note: This is only an approximate value because it does not take friction into account.

answer
Answers: 1

Other questions on the subject: Physics

image
Physics, 21.06.2019 17:00, genyjoannerubiera
The density of a substance is 4.0 g/cm3. if a sample of the substance has a volume of 25 cm3 then what is the mass
Answers: 1
image
Physics, 21.06.2019 22:50, Bt758
Two horizontal plates with infinite length and width are separated by a distance h in the z direction. the bottom plate is moving at a velocity u. the incompressible fluid trapped between the plates is moving in the positive x-direction with the bottom plate. align gravity with positive z. assume that the flow is fully-developed and laminar. if the systems operates at steady state and the pressure gradient in x-direction can be ignored, do the following: 1. sketch your system 2. identify the coordinate system to be used. 3. show your coordinates and origin point on the sketch. list all your assumptions. 5. apply the continuity equation to your system. nts of navier stokes equations of choice to your system 7. solve the resulting differential equation to obtain the velocity profile within the system make sure to list your boundary conditions. check units of velocity 8. describe the velocity profile you obtain using engineering terminology. sketch that on the same sketch you provided in (1). 9. obtain the equation that describes the volumetric flow rate in the system. check the units.
Answers: 2
image
Physics, 22.06.2019 09:00, perezsamantha3oqr0za
As a pendulum bob swings back and forth several times, the maximum height it reaches becomes less and less. this is because more and more of the pendulum bob's energy is being transformed into a. heat energy b. kinetic energy c. potential energy d. kinetic energy and potential energy
Answers: 2
image
Physics, 22.06.2019 11:10, axxpjr12
Consider an insulating crystal, made up of layers of atoms. what form would you expect the temperature dependence of the phonon heat capacity to approach at extremely low temperatures if the interlayer coupling is i)very strong (rigid coupling), and ii) very weak. explain.
Answers: 3
Do you know the correct answer?
The circumference you found in part A is in inches. To convert the circumference to miles, divide th...

Questions in other subjects: