Physics
Physics, 06.05.2021 20:40, miajacobs110

4 kg obics S mass 4 kg and H with mass 6 kg are connected
so that goes over a frictionless pulley (both these messes
5
be ignored as shown in the figure The blocks are released
move at tree will There is no friction between S and the table
Clearly indicate all forces acting on each block as shown in
the figure
Draw a free body diagram for each block and then calculate
the acceleration of each block
Calculate the tension in the string (2]
(ĺ››)
For blocks
For block H
C
and the
accen
forces ar
ifficult​

answer
Answers: 3

Other questions on the subject: Physics

image
Physics, 21.06.2019 22:00, jby
Atank holds 1000 gallons of water, which drains from the bottom of the tank in half an hour. the values in the table show the volume v of water remaining in the tank (in gallons) after t minutes. t(min) 5 10 15 20 25 30v(gal) 694 444 250 111 28 0(a) if p is the point (15, 250) on the graph of v, find the slopes of the secant lines pq when q is the point on the graph with t = 5, 10, 20, 25, and 30.(b) estimate the slope of the tangent line at p by averaging the slopes of two secant lines.(c) use a graph of the function to estimate the slope of the tangent line at p. (this slope represents the rate at which the water is flowing from the tank after 15 minutes.)show all steps.
Answers: 2
image
Physics, 22.06.2019 01:00, raweber
Avehicle has an oil leak that is causing the entire oil pan to be wet, but inspection reveals no exact source after cleaning off the oil residue. technician a says to install a fluorescent dye in the crankcase and operate the engine, then re-inspect for leaks with a special light (black light). technician b says the oil leak may be coming from a source at the top of the engine, such as a valve cover gasket. who is correct?
Answers: 1
image
Physics, 22.06.2019 10:00, Calirose
Suppose a wheel with a tire mounted on it is rotating at the constant rate of 2.15 times a second. a tack is stuck in the tire at a distance of 0.373 m from the rotation axis. noting that for every rotation the tack travels one circumference (a) find the tack's tangential speed. (b) what is the tacks radial acceleration?
Answers: 2
image
Physics, 22.06.2019 14:20, timothyashburn8
Antireflective coatings on solar cells are often made by applying a thin film of silicon nitride (sinx), which has an index of refractive of 1.2, on the top of the silicon solar cell, which has a refractive index of about 3.5. however, the sun emits radiation of various wavelengths which the solar cell absorbs, and the antireflective coating can only absolutely minimize the reflection of one of these wavelengths. the coating thickness is chosen to reduce the reflection of green/yellow light (e = 2.2 ev), which is the most intense color in the solar spectrum (shown below). which of the following coatings would minimize reflection of green/yellow light? the answer is 820 nm how? what is the angular width of the central maximum of an electron traveling at 2 x 108 m/s going through a single slit of width 1 mm.
Answers: 1
Do you know the correct answer?
4 kg obics S mass 4 kg and H with mass 6 kg are connected
so that goes over a frictionless pu...

Questions in other subjects:

Konu
Mathematics, 15.06.2020 20:57