Physics, 23.04.2021 04:10, megaboy

In 1989, Sandeep of California built the Frankencycle, a bicycle with a wheel diameter of more than 4 m. If you ride this bike so that
the wheels’ angular speed increases from 2.60 rad/s to 4.15 rad/s in
5.6 s, what is the average angular acceleration of the wheels?

Answers: 3

Show answers

Other questions on the subject: Physics

Physics, 21.06.2019 20:20, bnnn

An asteroid is discovered in a nearly circular orbit around the sun, with an orbital radius that is 2.47 times earth's. what is the asteroid's orbital period, its "year," in terms of earth years?

Answers: 1

continue

Physics, 22.06.2019 05:30, GreenHerbz206

Could someone . i have tried to solve myself but my calculation is off

Answers: 3

continue

Physics, 22.06.2019 05:30, yiikes4012

Will give brainliest! which statement best describes the difference between strong nuclear forces and weak nuclear forces? weak nuclear forces are involved when certain types of atoms break down. strong nuclear forces are responsible for holding atoms' nucleus together. weak nuclear forces hold bonds between atoms together. strong nuclear forces hold together the nucleus of an atom. strong nuclear bonds prevent atoms from falling apart. weak nuclear bonds prevent compounds from falling apart. strong nuclear forces are involved in breaking electrons from their shells. weak nuclear forces hold protons in the nucleus.

Answers: 3

continue

Physics, 23.06.2019 07:00, hockejoh000

Conventional hot-water heaters consist of a tank of water maintained at a fixed temperature. the hot water is to be used when needed. the drawback is that energy is wasted because the tank loses heat when it is not in use, and you can run out of hot water if you use too much. some utility companies are encouraging the use of on-demand water heaters (also known as flash heaters), which consist of heating units to heat the water as you use it. no water tank is involved, so no heat is wasted. a typical household shower flow rate is 2.50 gal/min (9.46 l/min ) with the tap water being heated from 51.0 ˚f (10.6 ˚c) to 120 ˚f (48.9 ˚c) by the on-demand heater. what rate of heat input (either electrical of from gas) is required to operate such a unit, assuming that all the heat goes into the water?

Answers: 3

continue

Do you know the correct answer?

In 1989, Sandeep of California built the Frankencycle, a bicycle with a wheel diameter of more tha...