Physics
Physics, 30.01.2020 19:56, Ezonthekid

Question 1 if you do 1,000 j of work on a system and remove 500 j of heat from it, what is the change in its internal energy?
a.-1,500 j
b.-500 j
c.1,500 j
d.500 j

question 2 the first law of thermodynamics is related to the conservation of which quantity?
a. matter
b. heat
c. work
d. energy

question 3 which of the following devices does not convert heat energy to mechanical energy?
a. internal combustion engine
b. windmill
c. steam turbine
d. coal-fueled power plant

question 4 which of the following statements correctly describes a heat engine?
a. work is used to transfer thermal energy from a hot reservoir to a cold one.
b. work is done by transferring thermal energy from a cold reservoir to a hot one. c. work is used to transfer thermal energy from a cold reservoir to a hot one.
d. work is done by transferring thermal energy from a hot reservoir to a cold one.

question 5 how much work can be extracted from 5.00 × 104 j of heat when 2.00 × 104 j of heat is exhausted?
a.7.00 × 104 j
b.3.00 × 104 j
c.3.00 × 104 j
d.7.00 × 104 j

question 6 which of the following statements would best describe how to increase the work done by a heat engine?
a. raise the temperature of the exhaust.
b. raise the temperature of the cold reservoir.
c. lower the temperature of the exhaust.
d. lower the temperature of the hot reservoir.

answer
Answers: 1

Other questions on the subject: Physics

image
Physics, 22.06.2019 05:00, kia9174
The earth is constantly spinning on its axis, like you might spin a basketball on your finger. it is this spinning of the earth that causes
Answers: 3
image
Physics, 22.06.2019 10:10, Kitty10101
Apair of 10μf capacitors in a high-power laser are charged to 1.7 kv. a. what charge is stored in each capacitor? b. how much energy is stored in each capacitor?
Answers: 2
image
Physics, 22.06.2019 12:30, decemberbooker2505
Brades exam guidelines exam instructions billing & payments & support question 6 of 20 : select the best answer for the question use this illustration to answer the question below. forms & resources al programs 9 ww linics 6. in the circuit shown in the figure above, suppose that the value of r, is 100k, and the value of r2 is 470 kq. at which of the following locations in the circuit would you measure the highest voltage with your meter? rvices 999999 a. between points b and c b. between points a and b c. between points b and e d. between points a and c eredu mark for review (will be highlighted on the review page) mend < < previous question next question
Answers: 1
image
Physics, 22.06.2019 17:40, kimberly01262016
The weights of bags filled by a machine are normally distributed with a standard deviation of 0.05 kilograms and a mean that can be set by the operator. at what level should the mean weight be set if it required that only 1% of the bags weigh less than 9.5 kilograms? round the answer to 2 decimal places.
Answers: 1
Do you know the correct answer?
Question 1 if you do 1,000 j of work on a system and remove 500 j of heat from it, what is the chang...

Questions in other subjects:

Konu
Mathematics, 12.04.2020 22:58
Konu
Chemistry, 12.04.2020 22:58
Konu
Mathematics, 12.04.2020 22:58