The graph shows did it from a brick being pushed along the concrete surface. What happened to the kinetic energy of the moving brick?
A. The brick has no energy wants to force had been removed.
B. The energy transformed into thermal energy.
C. The energy was used up so it no longer exists.
D. Some of the energy was destroyed.

Steam is generated in a boiler of a cogeneration plant at 10 mpa and 450°c at a steady rate of 5 kg/s. in normal operation, steam expands in a turbine to a pressure of 0.5 mpa and is then routed to the process heater, where it supplies the process heat. steam leaves the process heater as a saturated liquid and is pumped to the boiler pressure. in this mode, no steam passes through a condenser, which operates at 20 kpa. (a) determine the power produced in the turbine and the rate at which process heat is supplied in this mode. (b) determine the power produced in the turbine and the rate of process heat supplied if only 60 percent of the steam is routed to the process heater and the remainder is expanded to the condenser pressure. (3.32 mw; 9.69 mw; 4.25 mw; 5.82 mw)

Two steel balls, each of mass m, are welded to a light rod of length l and negligible mass and are initially at rest on a smooth horizontal surface. a horizontal force of magnitude f is suddenly applied to the rod as shown. determine (a) the instantaneous acceleration a of the mass center g and (b) the corresponding rate at which the angular velocity of the assembly about g is changing with time.

Acalorimeter uses the principle that thermal energy flows from hotter material to colder material until both reach the same