the ampere is used to measure electricity. an ampere is a unit of electric current equal. a unit of measure for the flow of current in a circuit. one ampere is the amount of current flow provided when one volt of electrical pressure is applied against one ohm of resistance.
Amachinist needs to remove a tight fitting pin of material a from a hole in a block made of material b. the machinist heats both the pin and the block to the same high temperature and removes the pin easily. what statement relates the coefficient of thermal expansion of material a to that of material b? a) the situation is not possible, heating block b will shrink the hole in the material as the material expands with increasing temperatureb) material b has the same coefficient of expansion as does material ac) material b has a negative coefficient of expansion and a has a positive coefficient of expansiond) material a has a greater coefficient of expansion than does material be) material b has a greate
Two horizontal plates with infinite length and width are separated by a distance h in the z direction. the bottom plate is moving at a velocity u. the incompressible fluid trapped between the plates is moving in the positive x-direction with the bottom plate. align gravity with positive z. assume that the flow is fully-developed and laminar. if the systems operates at steady state and the pressure gradient in x-direction can be ignored, do the following: 1. sketch your system 2. identify the coordinate system to be used. 3. show your coordinates and origin point on the sketch. list all your assumptions. 5. apply the continuity equation to your system. nts of navier stokes equations of choice to your system 7. solve the resulting differential equation to obtain the velocity profile within the system make sure to list your boundary conditions. check units of velocity 8. describe the velocity profile you obtain using engineering terminology. sketch that on the same sketch you provided in (1). 9. obtain the equation that describes the volumetric flow rate in the system. check the units.
Contrast the force of gravity between these pairs of objects: 1-kg mass and a 2-kg mass that are 1 m apart; a 1-kg mass and a 2-kg mass that are 2 m apart; and two 2=kg masses that are 1 m apart. i dont understand.