Physics
Physics, 30.03.2021 05:40, kvngsavage156

All of the following are true statements regarding line-voltage thermostats and control wiring except a. An electrician's license is often required to run line-voltage control wiring. b. Line-voltage thermostats must be matched to the voltage and current of the circuit. c. Line-voltage thermostats and controls are not as sensitive as low-voltage thermostats. d. Line-voltage thermostats and controls respond faster than low-voltage thermostats.

answer
Answers: 2

Other questions on the subject: Physics

image
Physics, 21.06.2019 22:30, droidd133
Fft review: linspace, fs, fftshift, nfft 1. generate one second of a cosine of w,-10hz sampled at f, = 100hz and assign it to x. define a tt as your time axis 2. take 64 points fft. 3. as you remember, the dft (which the fft implements) computes n samples of s2t where k-0,1,2, n -1. plot the magnitude of this 64-points fft at range 0 to 63, what do you think of this graph? 4â·to get the x-axis into a hz-frequency form, plot this 64-points fft between-50 to 50 (the 100hz sampling rate) and have n-points between them. 5. according to your figure, what frequency is this cosine wave at? 6. remember that the fft is evaluating from 0 to 2ď€. we are used to viewing graphs from-ď€ to ď€. therefore, you need to shift your graph. 7. now according to your shifted graph. what frequency is this at? 8. note that the spikes have long drop-offs? try a 1024-point dft. note that the peak is closer to 10 and the drop-off is quicker. although, now sidelobes are an issue
Answers: 2
image
Physics, 21.06.2019 22:50, 200052
A110-pound person pulls herself up 4.0 feet. this took her 2.5 seconds. how much power was developed? 0.13 hp 0.32 hp 2.0 hp 3.1 hp
Answers: 1
image
Physics, 22.06.2019 09:00, perezsamantha3oqr0za
As a pendulum bob swings back and forth several times, the maximum height it reaches becomes less and less. this is because more and more of the pendulum bob's energy is being transformed into a. heat energy b. kinetic energy c. potential energy d. kinetic energy and potential energy
Answers: 2
image
Physics, 22.06.2019 16:00, blythephillips2734
An charge with mass m and charge q is emitted from the origin, (x, y)=(0,0). a large, flat screen is located at x=l. there is a target on the screen at y position y(h), where y(h) > 0. in this problem, you will examine two different ways that the charge might hit the target. ignore gravity in this problem. 1.assume that the charge is emitted with velocity v(0) in the positive x direction. between the origin and the screen, the charge travels through a constant electric field pointing in the positive y direction. what should the magnitude e of the electric field be if the charge is to hit the target on the screen? express your answer in terms of m, q, y(h), v(0), and l. 2.now assume that the charge is emitted with velocity v(0) in the positive y direction. between the origin and the screen, the charge travels through a constant electric field pointing in the positive x direction. what should the magnitude e of the electric field be if the charge is to hit the target on the screen? express your answer in terms of m, q, y(h), v(0), and l.
Answers: 1
Do you know the correct answer?
All of the following are true statements regarding line-voltage thermostats and control wiring excep...

Questions in other subjects: