A student wearing frictionless in-line skates on a horizontal surface is pushed by a friend with a constant force of 50.0 N. How far must the student be pushed, starting from rest, so that her final kinetic energy is 350 J?
Pleas

In a steady-flow steam power plant system, two adiabatic high-pressure and low-pressure turbines ane used to generate power. superheated steam enters the high-pressure turbine at 8 mpa and 550°c. the steam expands in the high-pressure turbine to a saturated vapor at 3 mpa. in order to increase the powe generation of the power plant, another steam turbine working in a lower pressure ranges is deployed. the outlet vapor from the first turbine is heated up at a boiler to the temperature of 500 c at the constant pressure of first turbine's outlet (3 mpa). then, the vapor enters the second turbine and produces extra work. the exit conditions of the second turbine are 5o kpa and 90 percent quality. if the total power output of the power plant is 25 mw, determine a) the mass flow rate of the water (kg/s). b) heat transfer rate in the boiler (mw). (30 points) 3 mpa 00 c 8 mpa s0 c high pres turbine low pres boiler turbine 50 kpa 3 mpa 09 saturated vapor t heat engine, shown in the figure, operates between high temperature and low temperature of through a heat 4. a carnot tn and tu respectively. this heat engine receives energy from a heat reservoir at t exchanger where the heat transferred is proportional to the temperature difference as ? = k (z,-7, ). it rejects heat at a given low temperature tl. to design the heat engine for maximum work output, find the high temperature, th, as a function of tes and t. (15 points) qe

The key to stability is feedback between the reservoir and the fluxes into and/or out of the reservoir. assume that the rate of outflow from a reservoir depends on the size of the reservoir according to the following relationship: outflow rate= k x (size of reservoir), where k is a constant. a reservoir of water has a volume of 5000 liters, and the rate of outflow at steady state is 25 liters per minute. what is k? (give both the numerical value and its units.) what is the residence time? what is the relationship between k and the residence time?

Did the proton move into a region of higher potential or lower potential? did the proton move into a region of higher potential or lower potential? because the proton is a negative charge and it accelerates as it travels, it must be moving from a region of higher potential to a region of lower potential. because the proton is a negative charge and it accelerates as it travels, it must be moving from a region of lower potential to a region of higher potential. because the proton is a positive charge and it slows down as it travels, it must be moving from a region of higher potential to a region of lower potential. because the proton is a positive charge and it slows down as it travels, it must be moving from a region of lower potential to a region of higher potential. request answerpart bwhat was the potential difference that stopped the proton? express your answer with the appropriate units.î”v î” v = nothingnothingrequest answerpart cwhat was the initial kinetic energy of the proton, in electron volts? express your answer in electron volts. ki k i = nothing ev request answerprovide feedback