Physics, 08.03.2021 18:20, Lizzy527663

For these pictures is more or less friction needed?

Answers: 1

Show answers

Other questions on the subject: Physics

Physics, 22.06.2019 09:00, reyesortiz6955

In a heat engine if 1000 j of heat enters the system the piston does 500 j of work, what is the final internal energy of the system if the initial energy was 2000 j? 1. write the equation 2.list out your known variables 3.plug the numbers into the equations 4.solve 5.write your solution statement that includes initial energy and final

Answers: 1

continue

Physics, 22.06.2019 12:00, angelamirga332

Asolid round steel rod 6.25 mm in diameter and 375 mm long is rigidly bonded to the end of solid square brass rod 25 mm on a side and 300 mm long. the geometric axes of the bare are along the same line. an axial tensile force of 5.4 kn is applied at the extreme ends of the assembly. for steel e = 200 gpa and for brass e = 90 gpa. determine the total elongation for the assembly.

Answers: 1

continue

Physics, 22.06.2019 22:30, dlsmith68

Asailboat is traveling to the right when a gust of wind causes the boat to accelerate leftward at 2.5m/s2 for 4s. after the wind stops, the sailboat is traveling to the left with a velocity of 3.0m/s. assuming the acceleration from the wind is constant, what was the initial velocity of the sailboat before the gust of wind? answer using a coordinate system where rightward is positive.

Answers: 1

continue

Physics, 23.06.2019 05:30, efraruiz02

Oxygen gas enters well-insulated diffuser at 25 lbf/in.2, 420r, with a velocity of 860 ft/s through a flow area of 1.6 in.^2. at the exit, the flow area is 12 times the inlet area, and the velocity is 19 ft/s. the potential energy change from inlet to exit is negligible. assuming ideal gas behavior for the oxygen and steady-state operation of the diffuser, determine the following: (a) the exit temperature, in r(b) the exit pressure, in lbf/in.^2 (c) the mass flow rate, in lb/s