Physics
Physics, 24.02.2021 02:20, destiniout04231

PLEASE HELP IM BEGGING A 2kg toy car with an initial velocity of 1.2m/s rear-ends a 5 kg toy truck moving
in the same direction as the car at a speed of 0.4m/s. After the collision, the car is seen to bounce backward at a speed of 0.2 m/s.

1. what’s the total momentum before the collision?

2. what's the total momentum after the collision?

answer
Answers: 2

Other questions on the subject: Physics

image
Physics, 21.06.2019 23:00, xojade
Athermometer is removed from a room where the temperature is 70° f and is taken outside, where the air temperature is 10° f. after one-half minute the thermometer reads 60° f. what is the reading of the thermometer at t = 1 min? (round your answer to two decimal places.) ° f how long will it take for the thermometer to reach 30° f? (round your answer to two decimal places.)
Answers: 3
image
Physics, 21.06.2019 23:30, schapethan
In order for the bug to fly through the air a force has to push the bug forward. identify this force. how does the bug produce
Answers: 1
image
Physics, 22.06.2019 01:00, anna4060
First, launch the video below. you will be asked to use your knowledge of physics to predict the outcome of an experiment. then, close the video window and answer the question at right. you can watch the video again at any point. part a as in the video, we apply a charge +q to the half-shell that carries the electroscope. this time, we also apply a charge –q to the other half-shell. when we bring the two halves together, we observe that the electroscope discharges, just as in the video. what does the electroscope needle do when you separate the two half-shells again? view available hint(s) as in the video, we apply a charge + to the half-shell that carries the electroscope. this time, we also apply a charge – to the other half-shell. when we bring the two halves together, we observe that the electroscope discharges, just as in the video. what does the electroscope needle do when you separate the two half-shells again? it deflects more than it did at the end of the video. it deflects the same amount as at end of the video. it does not deflect at all. it deflects less than it did at the end of the video. submit
Answers: 2
image
Physics, 22.06.2019 02:50, lilybear1700
Steam is generated in a boiler of a cogeneration plant at 10 mpa and 450°c at a steady rate of 5 kg/s. in normal operation, steam expands in a turbine to a pressure of 0.5 mpa and is then routed to the process heater, where it supplies the process heat. steam leaves the process heater as a saturated liquid and is pumped to the boiler pressure. in this mode, no steam passes through a condenser, which operates at 20 kpa. (a) determine the power produced in the turbine and the rate at which process heat is supplied in this mode. (b) determine the power produced in the turbine and the rate of process heat supplied if only 60 percent of the steam is routed to the process heater and the remainder is expanded to the condenser pressure. (3.32 mw; 9.69 mw; 4.25 mw; 5.82 mw)
Answers: 3
Do you know the correct answer?
PLEASE HELP IM BEGGING A 2kg toy car with an initial velocity of 1.2m/s rear-ends a 5 kg toy truck...

Questions in other subjects: