1
Fig. 1.1 shows a spring hanging from a wooden rod with a load attached to the lower end of
...
Physics, 07.02.2021 07:00, jessieeverett432
1
Fig. 1.1 shows a spring hanging from a wooden rod with a load attached to the lower end of
the spring
wooden rod
spring
load
bench
Fig. 1.1
(a) On Fig. 1.1, mark
(i) the length 1 of the spring,
[1]
(ii) the position of the ruler used to measure the length I
(iii) where you would position your eye to determine the reading for the bottom of the
spring
[1]
Answers: 1
Other questions on the subject: Physics
Physics, 22.06.2019 05:30, mlopezmanny5722
The a992 steel rod bc has a diameter of 50 mm and is used as a strut to support the beam. determine the maximum intensity w of the uniform distributed load that can be applied to the beam without risk of causing the strut to buckle. take f. s. = 2 against bucklin
Answers: 3
Physics, 22.06.2019 14:40, babygirl091502
The experiment done in lab is repeated, using a ball that has unknown mass m. you plot your data in the form of f 2 versus m/l, with f in rev/s, m in kg, and l in m. your data falls close to a straight line that has slope 3.19 m/(kg · s2). use g = 9.80 m/s2 and calculate the mass m of the ball.
Answers: 1
Physics, 22.06.2019 18:30, yuvraj2298
Ahot-air balloon takes off from the ground traveling vertically with a constant upward acceleration of magnitude g/4. after time interval δt, a crew member releases a ballast sandbag from the basket attached to the balloon. how many seconds does it take the sandbag to reach the ground? (express your answer in terms of δt)
Answers: 2
Do you know the correct answer?
Questions in other subjects:
Social Studies, 21.09.2021 05:00
Mathematics, 21.09.2021 05:00
English, 21.09.2021 05:00
English, 21.09.2021 05:00
