Physics
Physics, 03.02.2020 14:59, smallblueberry

If vector a ⃗ has components a x and a y and makes an angle θ with the +x axis, then

answer
Answers: 2

Other questions on the subject: Physics

image
Physics, 22.06.2019 11:30, slim2077
Two 1.20-m nonconducting wires meet at a right angle. one segment carries + 2.50 µc of charge distributed uniformly along its length, and the other carries - 2.50 µc distributed uniformly along it, as shown in fig. 21.50. ( a. find the magnitude and direction of the electric field these wires produce at point p, which is 60.0 cm from each wire. ( b. if an electron is released at p, what are the magnitude and direction of the net force that these wires exert on it?
Answers: 3
image
Physics, 22.06.2019 11:30, chelsilconway2262
This punnett square shows the cross between two pants. one parent has round seeds (rr). and the other parent has wrinkled seeds (rr) which best describes their offspring as shown in this cross?
Answers: 2
image
Physics, 22.06.2019 16:10, Wemaybewrong
Amass weighing 24 pounds, attached to the end of a spring, stretches it 4 inches. initially, the mass is released from rest from a point 8 inches below the equilibrium position. find the equation of motion. (use g = 32 ft/s2 for the acceleration due to gravity.)
Answers: 1
image
Physics, 22.06.2019 21:40, iancuteodora30
Ahair dryer is basically a duct in which a few layers of electric resistors are placed. a small fan pulls the air in and forces it through the resistors where it is heated. air enters a 1200 w hair dryer at 100 kpa and 22°c and leaves at 47°c. the cross-sectional area of the hair dryer at the exit is 60 cm2. neglecting the power consumed by the fan and the heat losses through the walls of the hair dryer, determine (a) the volume flow rate of air at the inlet and (b) the velocity of the air at the exit.
Answers: 1
Do you know the correct answer?
If vector a ⃗ has components a x and a y and makes an angle θ with the +x axis, then...

Questions in other subjects:

Konu
History, 18.07.2019 15:00
Konu
Physics, 18.07.2019 15:00