Physics
Physics, 27.01.2021 14:00, tomboyswagge2887

2.5 The following readings were obtained in acooling experiment:
Temperature (8°C) 36.0 35.2 34.2 33.0 32.5 32.0 31.6 31.5 31.3 31.131.0
Time (min) 0 1 2
3 4 5 6 7 8 9 10
514
Ra 0,4
Plot a graph of O against t. From the graph determine the time for the temperature to
fall from 35.0°C to 31.2°C. Measure the rate of fall of temperature at points 34.5, 33.2
and 31.2.
2.8 The two scientists Dulong and Petit found that the rate of loss of heat is
proportional to 0,", i. e.
2.38
Hence,
R= k0,
2.39
Where is the excess temperature, which is equalto:
0-OR
2.40
Where Or is the temperature of the surrounding; verify this law using the
appropriate graph (take O, to be 29°C). Find the slope and its attendant erro
What does the slope of this graph represent? / explain the implication of th
graph. (Use the Table in exercise 2.5 above).
514

answer
Answers: 1

Other questions on the subject: Physics

image
Physics, 21.06.2019 18:30, iliketurtures
Three archers each fire four arrows at a target. joe’s four arrows hit at points 10 cm above, 10 cm below, 10 cm to the left, and 10 cm to the right of the center of the target. all four of moe’s arrows hit within 1 cm of a point 20 cm from the center, and flo’s four arrows hit within 1 cm of the center. the contest judge says that one of the archers is precise but not accurate, another archer is accurate but not precise, and the third archer is both accurate and precise. which description applies to which archer? explain
Answers: 2
image
Physics, 21.06.2019 22:30, gd9075
Abug is 12 cm from the center of a turntable that is rotating with a frequency of 45 rev/min . what minimum coefficient friction is required so that the bug stays on the turntable?
Answers: 1
image
Physics, 22.06.2019 00:40, naomicervero
The rigid beam is supported by the three suspender bars. bars ab and ef are made of aluminum and bar cd is made of steel. if each bar has a cross-sectional area of 450 mm2, determine the maximum value of p if the allowable stress is (σallow)st = 200 mpa for the steel and ( σallow)al = 150 mpa for the aluminum. est = 200 gpa and eal = 70 gpa.
Answers: 1
image
Physics, 22.06.2019 04:50, gabriellam20
Describe the function of the endomembrane system? what organelles are involved?
Answers: 3
Do you know the correct answer?
2.5 The following readings were obtained in acooling experiment:
Temperature (8°C) 36.0 35.2...

Questions in other subjects:

Konu
Mathematics, 08.05.2021 20:20
Konu
Mathematics, 08.05.2021 20:20
Konu
Geography, 08.05.2021 20:20